Table of Contents
Advertisement
CMS-700 SYSTEM CIRCUIT MONITORING SYSTEM (CMS)
—
Installation Guide
—
Mounting of System pro M compact and SMISSLINE Sensors
• Sensors fit to all ABB installation devices with twin terminals
• Flat cable should not exert force on the sensor, otherwise measuring errors may occur
• Sensors fit ABB MCBs (S200, SMISSLINE) and RCBOs (SMISSLINE)
• Flat cable should not exert force on the sensor, otherwise measuring errors may occur
—
Mounting Sensors on DIN-Rails
• Sensors can be mounted on all 35-mm DIN-Rails (DIN50022)
• The cable should not exert force on the sensor, otherwise measuring errors may occur
1. Unscrew the terminal of the installation
device. Plug in the metal pin of the sensor
into rear terminal connection.
2. Put the cable through the opening of the
sensor into the installed device. The cable
has to be insulated within the sensor!
3. Then tighten the screw.
1. Insert the sensor on the existing device,
in order to have the cable passing through
the opening of the sensor.
2. Snap the adapter of the sensor on the upper
screw hole of the already installed device.
1. Snap in the bracket on the DIN-rail.
2. Insert the cable into the installed device
through the opening on the sensor.
The cable has to be insulated within the
sensor.
3. Fix the cable with a cable tie.
4. Snap in the Sensor on the bracket.
21
- Quick Links:
- Network Connection
Hide quick links:
Advertisement
Table of Contents
