Page 1
GM1200E Mobile Radio Dealer Programming Software (DPS) Installation Manual 68P64113B09 European Publications Department (RPG) Fleet, Hampshire, England Issue: May 1998...
Page 3
Table of Contents Chapter 1 DPS Installation Table of Contents Paragraph Page Introduction ....................1 GM1200E Mobile Radio Connection Information ........2 Configuring the RIB and GM1200E Radio..........2 Installing the Dealer Programming Software .......... 3 DPS Installation...
Introduction Introduction This chapter provides an overview of the GM1200E Dealer Programming Software (DPS) and shows how to connect the radio to a computer and install the programming software. The user manual for the DPS is contained within the application and can be printed if required. The user manual is independant of the DPS screens and can be viewed at any time during programming.
Figure 1-1 GM1200E Radio Programming Setup. Configuring the RIB and GM1200E Radio Connect the RIB to the computer (Figure 1-1) using the interface cable 3080369B71 or 3080369B72 depending on the computer connection to Serial COM Port 1. If you are unsure of the connection on the back of your computer or the COM port, then please consult the computer manuals.
To run the DPS , from the Taskbar select the START menu and via the Program menu select the GM1200E DPS or: If selection is made via the menus, from the Explorer menu select FILE, then select RUN and then BROWSE on the C: drive to find the GM1200E DPS file and then select OK. DPS Installation...
Page 8
Installing the Dealer Programming Software DPS Installation...