Two identical coils on the outer OPERATION legs of the laminated structure are connected to the The type CA-16 relay is an induction disc relay with secondary (tapped section) of the autotransformer four electromagnets mounted on two discs that are winding in a manner so that the combination of all fastened on a common shaft.
41-337.31 C CHARACTERISTICS ENERGY REQUIREMENTS Burden of each restraint coil at 5 amperes 4.1. CA-16 Bus Relay VOLT AMPERES POWER FACTOR This relay has variable percentage characteristics which means that the operating coil current Continuous Rating 14 amperes required to close the relay contacts, expressed in...
Percentage Differential Characteristic 7.1. Contacts Apply 16 amperes to terminals 9 and 19 of the CA-16 Adjust the adjustable stop screw on the upper disc of relay. The contacts should close when the following the relay so that a contact separation of 0.050 inch is...
Connect the relay per the test circuit of Figure 8. lock nut. Back off the Micarta disc by loosening the Pass 20 amperes for the CA-16 relay into terminals 9 two lock nuts. Apply 0.15 amperes to terminals 14 and 19 of the relay. Adjust the plug (when used) in and 15.
Page 7
41-337.31 C Sub 1 3532A95 Figure 3. Internal Schematic of the Type CA-16 Bus Relay...