Installation
1. Place the oven on a flat surface with a sufficient amount of space
around the appliance to ensure the proper function of exhaust
vents
The minimum distance between the oven and the closest wall
must be 7.5 cm.
At least one side must be open space.
1) Leave at east 30 cm of free space above the oven.
2) Do not remove oven legs.
3) Do not block exhaust vents. Blocking the exhaust vents could
cause damage.
4) Place the oven as far away from the radio or television as possible.
The microwave oven can interfere with the television and radio signal.
2. Connect the oven to a standard electricity network. Make sure the voltage and frequency on the oven label corresponds with the
network voltage and frequency.
ATTENTION: Do not install the oven above, or near the stove or near another source of heat. Placing the oven by a
heat source could damage the oven and result in losing the warranty.
The microwave oven should be used in an open space and should not be placed in a cabinet.
The surface of the microwave oven can become hot during operation.
OVEN FUNCTIONS
Operating instructions
This microwave oven uses modern electronic controlling to configure cooking parameters to better meet your needs.
1. Setting the time
As soon as you connect the microwave oven into the outlet, "0:00" begins flashing on the oven display.
1) Press the Clock/Pre-Set button, the two digit number for setting the hours begins to flash.
2) Set the hours between 0-23 via "
3) Press the Clock/Pre-Set button, the two digit number for setting the minutes begins to flash.
4) Set the hours between 0-59 via "
5) Press the Clock/Pre-Set button to complete the time setting process. The colon " : " will flash.
Note:
1)
The oven will not function properly without the time begin set.
You can press the Stop/Clear button at any moment during the time setting and the oven will return to its previous state.
2)
2. Cooking in the microwave oven
1) Press the Microwave button once. "P100" will be displayed.
2) Press the Microwave button several times or turn "
successively show "P100", "P80", "P50", "P30", "P10".
3) Confirm by pressing the Start/+30Sec./Confirm button.
4) Set the cooking duration by turning "
5) Press the Start/+30Sec./Confirm button and the oven begins to cook.
Note: When setting the cooking duration, the step between values from seconds to minutes changes depending on the overall time.
See the following:
MTD 202 S CZ+SK+PL+HU+DE+EN.indb 53
7.5 cm
7.5 cm
".
".
" and select the cooking power from 100% to 10%. The display will
" (time interval ranges between 0:05 to 95:00).
30 cm
Opening
Hot surface!
EN
53
17.2.2011 17:38:34