Parameter Setting - Siemens ET 200SP Manual
Technology module tm pulse 2x24v
Hide thumbs
Also See for ET 200SP:
- System manual (320 pages) ,
- Manual (270 pages) ,
- Operating instructions manual (166 pages)
Table of Contents
Advertisement
4.1.4
Parameter setting
You use various parameters to specify the properties of the technology module. Depending
on the settings, not all parameters are available. When parameters are assigned in the user
program, the parameters are transferred to the module with the "WRREC" instruction and
data record 128 (Page 155).
You set the parameters of the module as follows in this operating mode:
Parameter setting via...
Hardware configuration in
STEP 7 (TIA Portal)
Hardware configuration in
STEP 7 with HSP
Hardware configuration with
GSD file for distributed
operation on PROFINET IO
Hardware configuration with
GSD file for distributed
operation on
PROFIBUS DP
Technology Module TM Pulse 2x24V (6ES7138‑6DB00‑0BB1)
Manual, 05/2019, A5E35061186-AB
Basic procedure
1. Insert the module from the hardware catalog under "Technology
modules".
2. Set the "Pulse output" mode and the further parameters of the
module in the hardware configuration.
3. Download the project to the CPU.
1. Install the corresponding HSP file.
You will then find the module in the hardware catalog under
"ET 200SP".
2. Set the "Pulse output" mode and the further parameters of the
module in the hardware configuration.
3. Download the project to the CPU.
1. Install the latest PROFINET GSD file.
You will then find the module in the hardware catalog under "Other
field devices > PROFINET IO > I/O".
2. Set the "Pulse output" mode and the further parameters of the
module in the hardware configuration.
3. Download the project to the CPU.
1. Install the latest PROFIBUS GSD file.
You will then find the module in the hardware catalog under "Other
field devices > PROFIBUS DP > I/O".
2. Download the project to the CPU.
The parameters of the module are also downloaded with their de-
fault settings (see table below).
3. Set the "Pulse output" mode and the further parameters in the user
program using data record 128.
Configuring/address space
4.1 Pulse output (single pulse) mode
27
Hide quick links:
Advertisement
Table of Contents
