Page 1
By inserting the camera in the waterproof case, you can shoot movies at a waterfront. 1. Slide the buckle lock in the direction of and hold it, then hold the circled parts and swing out the buckle in the direction of FDR-X1000V (SPK-X1) HDR-AS200V (SPK-AS2)
Page 2
2. Open the case cover. 3. Insert the camera in the case body. Release the REC HOLD (lock) switch on the camera. FDR-X1000V (SPK-X1) HDR-AS200V (SPK-AS2) 4. Insert the tab of the case body into the slot of the case cover.
Page 3
5. Hook the buckle over the tab on the lower part of the case cover , then close the buckle in the direction of , until it clicks into place. Make sure the buckle is locked by the buckle lock. FDR-X1000V (SPK-X1) HDR-AS200V (SPK-AS2)
Page 4
Note You cannot operate the REC button when the REC HOLD switch is set to the lock position. Release the lock in the direction of the arrow below, before operation. FDR-X1000V (SPK-X1) HDR-AS200V (SPK-AS2)
Page 5
When the camera is inserted in the supplied waterproof case, the waterproof performance is as follows. FDR-X1000V (SPK-X1) is operable up to a water depth of 10 m for 60 minutes. HDR-AS200V (SPK-AS2) is operable up to a water depth of 5 m for 30 minutes.
Page 6
If you do not use the anti-fog sheet, place it in a bag and keep the top sealed. By drying the anti-fog sheet sufficiently, you can use it approximately 200 times repeatedly. SPK-X1 (supplied with FDR-X1000V) When using the optional anti-fog sheet (AKA-AF1), place it in the gap on the opposite side of the camera display.
In the unlikely event that a malfunction of the waterproof case causes damage due to water leakage, Sony does not guarantee against damages to the equipment contained in it (camera, battery pack, etc.) and the recorded contents, nor expenses entailed in the photography.
When finding a malfunction of waterproof case If a malfunction is found by inspection of the waterproof packing or check for water leaks, stop using this unit immediately and take it to the nearest Sony dealer. [16] How to use...