Advertisement
Quick Links
Cubetape PRO Quickstart Guide
Exterior Overview
Press to record measure
Scan barcode
All buttons can be used for navigation under menu mode except for
Power On/Off
To turn on the device, once press
To shut down the device, press
'power off' is indicated on screen (or 5 beeps are heard).
Insert Pallet
While the cursor is in the length field, press
Return to Last Recorded Data
Press
several times until the curser is in the length filed:
Press
will display the last recorded measurement on screen.
Append
The append function enables the operator to sum three measurements of length together, especially
when the item length is longer than the 3 meter tape.
After measuring length 1, press
Measure length 2 and length 3;
Record appended measurement by pressing
The length recorded will be the sum of length 1, 2 and length 3.
www.cubetape.com
USB Port
Charge Light
LED
Send data record
Append; save data
.
for approximately 3 seconds, then release when
or
to insert the default length and width.
to append;
or
Tape Tip
Tape Tip
Rubber Boot Protective
Backspace; power on/off
;
Battery Compartment
Tape Cassette
1
Advertisement
Related Manuals for CUBETAPE PRO
Summary of Contents for CUBETAPE PRO
- Page 1 Cubetape PRO Quickstart Guide Exterior Overview USB Port Charge Light Tape Tip Battery Compartment Tape Tip Rubber Boot Protective Tape Cassette Press to record measure Send data record Backspace; power on/off Scan barcode Append; save data All buttons can be used for navigation under menu mode except for...
- Page 2 Remove and replace the battery by slightly press the trough at the middle edge of the battery upward. Remove and replace the tape cassette by turning Cubetape PRO over, extracting the tape a few centimeters and then lifting the tape away from the device slowly.