Installing A Dc Power Supply - Cisco Catalyst 3650 Series Hardware Installation Manual
Hide thumbs
Also See for Catalyst 3650 Series:
- Command reference manual (1108 pages) ,
- Configuration manual (94 pages) ,
- Manual (94 pages)
Table of Contents
Advertisement
Installing a DC Power Supply
Do not leave the power supply slot open for more than 90 seconds while the switch is operating.
Caution
Warning
This unit might have more than one power supply connection. All connections must be removed to
de-energize the unit. Statement 1028
Step 5
Insert the new power supply into the power supply slot, and gently push it into the slot
When correctly inserted, the 250-W, 640-W, and 715-W power supply modules (excluding the power
cord retainer) are flush with the switch's rear panel. The 1025-W and 1100-W power supply modules
extend 1.5 inches from the switch's rear panel.
Figure 4-8
(Optional) Make a loop in the power cord and thread it through the power cord retainer
Step 6
Figure 4-9
Step 7
Connect the power cord to the power supply and to an AC power outlet. Turn on the power at the power
source.
Step 8
Confirm that the power supply AC OK and PS OK LEDs are green.
Installing a DC Power Supply
•
Catalyst 3650 Switch Hardware Installation Guide
4-8
Inserting the AC Power Supply in the Switch
AC Power Supply with Power Cord Retainer
A C O K
A C
2- 25 0W
P W R -C
P S O K
A C O K
Equipment That You Need, page 4-9
PWR -C2- 640W AC
A C
2- 64 0W
P W R -C
P S O K
Chapter 4
Power Supply Installation
(Figure
PWR -C2- 640W AC
(Figure
OL-29734-01
4-8).
4-9).
Hide quick links:
Advertisement
Table of Contents
