Handling - Transport; Check Before Starting - Husqvarna FS 400 LV Operator's Manual
Hide thumbs
Also See for FS 400 LV:
- Operator's manual (104 pages) ,
- Manual (12 pages) ,
- Price list (48 pages)
Table of Contents
Advertisement
Available languages
Available languages
04 - Water intake tap
05 - Service spanner
06 - Engine Moteur
07 - Disk casing Carter de disque
08 - Front guide Guide avant
09 - Lifting ring Anneau d'élingage
10 - Belt cover Carter de courroies
11 - Engine oil Sortie de vidange moteur
12 - Motor tensioning screw
13 - Tank
14 - Motor stop
15 - Circuit breaker
16 - Connector
17 - RCCB
18 - RCCB connector
19 - Wheel Lock
4 – HANDLING - TRANSPORT
Switch off the disk prior to moving the
machine on jobsite.
Remove the disk prior to hoisting,
loading, unloading and transporting
the machine on jobsite.
Height of the handle-bar adjustable by pivoting.
•
To position the floorsaw on the site, simply push
•
it. It will move easily on its four wheels without
starting the engine.
For transporting by vehicle or by any kind of lifting
•
gear, there is a factory-fitted hoisting point on the
machine.
5 – CHECK BEFORE STARTING
Please read the instructions for use
prior to operating the machine for the
first time.
Moteur off.
The working area must be completely
cleared, well lit and all safety hazards
removed (no water or dangerous
objects in the vicinity).
The
mandatory.
Any persons not involved in the work
should leave the working area.
Use
maximum operating speed greater
than blade shaft speed
Petrol
engine
maintenance manual) :
Take
conditions from health and safety
point of wiew.
Check that the fuel tank is full.
•
Check that the engine oil level is correct. As the
•
engine often operates at an angle, check the oil
level (with the engine horizontal) frequently to
ensure that it never falls below the second mark
on the dipstick.
For starting up refer to the engine handbook.
•
Machine with electric motor. Check the following:
The RCCB must be used correctly,including
•
testing it regularly. For tools supplied with an
integral RCCB in the cable or in the mains plug, if
the cable or plug has been damaged, repairs
must be carried out by the manufacturer, one of
his agents or by a qualified repair workshop to
avoid any risks resulting from errors.
Motor power supply: reinforced electric cable with
•
4 (3P+E) or 5 (3P+N+E) conductors 2.5 mm2 for
lengths less than 100 m.
Earthing of the machine (mandatory).
•
Mains voltage (400 V).
•
Direction of rotation of the motor : Direction of
•
rotation on the right hand side of the cover (if the
motor does not turn in the direction required
E
n
g
s i l
h
- 3/6
The
operator
protective
appropriate to the work he is
doing.
use
of
ear
only
blades
marked
machine
(consult
into
account
ELECTRICAL SAFETY : Operate
•
this machine only on a supply
equipped with a 30 mA earthed
current-limiting
Otherwise, consult our catalogue for
appropriate models.
must
wear
clothing
protection
is
with
a
the
engine
the
working
circuitbreaker.
Advertisement
Table of Contents
