This guide addresses only those items. You should use good judgment to identify potential safety hazards due to attachment of non-Lenovo features or options not covered by this inspection guide.
4. Check for cracked or bulging batteries. 5. Remove the cover. 6. Check for any obvious non-Lenovo alterations. Use good judgment as to the safety of any non-Lenovo alterations. 7. Check inside the unit for any obvious unsafe conditions, such as metal filings, contamination, water or other liquids, or signs of fire or smoke damage.
• English • Arabic • Brazilian Portuguese • French • German • Hebrew • Japanese • Korean • Spanish • Traditional Chinese DANGER DANGER DANGER Yoga Slim 7i Pro (14″, 5), Yoga Slim 7 Pro (14″, 5) Hardware Maintenance Manual...
• Check for obvious damage to a hard disk drive. If the spindle of a hard disk drive becomes noisy, the hard disk drive might have been dropped or subject to excessive force. CRU list Type ac power adapter self-service power cord self-service Yoga Slim 7i Pro (14″, 5), Yoga Slim 7 Pro (14″, 5) Hardware Maintenance Manual...
Chapter 3. Idetifying FRUs (CRUs) Locate FRUs and CRUs The exploded illustrations help Lenovo service technicians identify FRUs or CRUs that they may need to replace when servicing a customer’s computer. Figure 1. Exploded view Table 1. FRU (CRU) categories...
Page 30
Charger thermal pad I/O bracket Coin-cell battery Wi-Fi card Heatsink Speakers Lower case M.2 solid-state drive System board I/O board cable Battery pack TP FFC cable Yoga Slim 7i Pro (14″, 5), Yoga Slim 7 Pro (14″, 5) Hardware Maintenance Manual...
Page 31
Figure 2. LCD exploded view (for glass models) Table 2. FRU (CRU) categories FRU (CRU) category LCD cover Hinge cover Strip cover Hinge EDP cable LCD panel Removable tapes Camera Camera cable Chapter 3 Idetifying FRUs (CRUs)
Page 32
Table 2. FRU (CRU) categories (continued) Microphone rubber Camera rubber Yoga Slim 7i Pro (14″, 5), Yoga Slim 7 Pro (14″, 5) Hardware Maintenance Manual...
Chapter 4. Removing a FRU or CRU Service tools The following table lists tools for servicing Lenovo computers. Tools with a cross mark are needed for serving the product models as described by this publication. Prepare them before you service the product.
Place the computer upside down on a flat surface. Step 2. Remove seven screws and then remove the lower case. Figure 4. Remove seven screws Yoga Slim 7i Pro (14″, 5), Yoga Slim 7 Pro (14″, 5) Hardware Maintenance Manual...
Screw specifications Number of screws M2 x L5.5 M2 x L3.5 Go to to look up the Lenovo part numbers of the following https://support.lenovo.com/partslookup replacement part: Lower case Remove the battery pack Make sure the following FRUs (or CRUs) have been removed.
Disconnect the battery pack cable. Attention: Use your fingernail to pull the connector to unplug it. Do not pull the cable. Figure 7. Disconnect the battery pack Yoga Slim 7i Pro (14″, 5), Yoga Slim 7 Pro (14″, 5) Hardware Maintenance Manual...
Figure 8. Remove the solid-state drive Screw specifications Number of screws M2 x L1.8 Go to to look up the Lenovo part numbers of the following https://support.lenovo.com/partslookup replacement part: M.2 solid-state drive Remoeve the Wi-Fi card Make sure the following FRUs (or CRUs) have been removed.
Page 40
Screw specifications Number of screws M2 x L1.8 Step 3. Disconnect the Wi-Fi card antennas and then slide the Wi-Fi card out of the slot. Yoga Slim 7i Pro (14″, 5), Yoga Slim 7 Pro (14″, 5) Hardware Maintenance Manual...
Figure 11. Remove the Wi-Fi card Go to to look up the Lenovo part numbers of the following https://support.lenovo.com/partslookup replacement part: Wi-Fi card Remove the fan Make sure the following FRUs (or CRUs) have been removed. “Remove the lower case” on page 30 Step 1.
Page 42
Disconnect the fan cables and then remove the fan. Figure 14. Remove the fan Go to https://support.lenovo.com/partslookup to look up the Lenovo part numbers of the following replacement part: Yoga Slim 7i Pro (14″, 5), Yoga Slim 7 Pro (14″, 5) Hardware Maintenance Manual...
Remove the heatsink Make sure the following FRUs (or CRUs) have been removed. “Remove the lower case” on page 30 Step 1. Disconnect the battery pack cable. Attention: Use your fingernail to pull the connector to unplug it. Do not pull the cable. Figure 15.
Attention: Use your fingernail to pull the connector to unplug it. Do not pull the cable. Figure 17. Disconnect the battery cable Step 2. Remove two screws and then remove the I/O bracket. Yoga Slim 7i Pro (14″, 5), Yoga Slim 7 Pro (14″, 5) Hardware Maintenance Manual...
Screw specifications Number of screws M2 x L4 Go to https://support.lenovo.com/partslookup to look up the Lenovo part numbers of the following replacement part: I/O bracket Remove the touch pad Make sure the following FRUs (or CRUs) have been removed. “Remove the lower case” on page 30 “Remove the battery pack”...
Lenovo part numbers of the following replacement part: Touch pad Remove the speakers Make sure the following FRUs (CRUs) have been removed. Yoga Slim 7i Pro (14″, 5), Yoga Slim 7 Pro (14″, 5) Hardware Maintenance Manual...
Page 47
I/O board. Figure 21. Disconnect cables Step 2. Carefully remove the speakers. Figure 22. Remove speakers Go to to look up the Lenovo part numbers of the following https://support.lenovo.com/partslookup replacement parts: Speakers Chapter 4 Removing a FRU or CRU...
Step 2. Disconnect the EDP cable, camera cable, speaker cable, keyboard cable, keyboard backlight cable, touch pad cable and antenna cable from the system board. Yoga Slim 7i Pro (14″, 5), Yoga Slim 7 Pro (14″, 5) Hardware Maintenance Manual...
Page 49
Figure 24. Disconnect all cables Step 3. Remove the system board. Figure 25. Remove the system board Step 4. Disconnect the coin-cell battery cable. Chapter 4 Removing a FRU or CRU...
Disconnect the battery pack cable. Attention: Use your fingernail to pull the connector to unplug it. Do not pull the cable. Figure 27. Disconnect the battery cable Yoga Slim 7i Pro (14″, 5), Yoga Slim 7 Pro (14″, 5) Hardware Maintenance Manual...
Page 51
Step 2. Remove six screws. Figure 28. Remove six screws Screw specifications Number of screws M2 x L5.5 Step 3. Open the hinges for about 90 degree. Figure 29. Open the hinges Step 4. Remove the upper case from the LCD module. Chapter 4 Removing a FRU or CRU...
Remove the M.2 solid-state drive thermal pad. Figure 31. Remove the M.2 solid-state drive thermal pad Go to https://support.lenovo.com/partslookup to look up the Lenovo part numbers of the following replacement part: Yoga Slim 7i Pro (14″, 5), Yoga Slim 7 Pro (14″, 5) Hardware Maintenance Manual...
Step 1. Remove the M.2 solid-state drive thermal pad. Figure 32. Remove the M.2 solid-state drive thermal pad Go to to look up the Lenovo part numbers of the following https://support.lenovo.com/partslookup replacement part: Charger thermal pad Remove the hinge cover Make sure the following FRUs (or CRUs) have been removed.
“Remove the upper case” on page 44 “Remove the hinge cover” on page 47 Step 1. Pull out the cables. Figure 34. Remove the hinge cover Yoga Slim 7i Pro (14″, 5), Yoga Slim 7 Pro (14″, 5) Hardware Maintenance Manual...
Page 55
Screw specifications Number of screws M2 x L5.5 Step 3. Remove the hinges. Figure 36. Remove the hinges Go to https://support.lenovo.com/partslookup to look up the Lenovo part numbers of the following replacement part: Hinge Chapter 4 Removing a FRU or CRU...
“Remove the hinge cover” on page 47 Step 1. Remove the hinge cover. Figure 37. Remove the hinge cover Step 2. Remove six screws. Figure 38. Remove six screws Yoga Slim 7i Pro (14″, 5), Yoga Slim 7 Pro (14″, 5) Hardware Maintenance Manual...
M2 x L5.5 Step 3. Remove the hinges. Figure 39. Remove the hinges Go to to look up the Lenovo part numbers of the following https://support.lenovo.com/partslookup replacement part: Hinge Remove the strip cover (for glass models) Make sure the following FRUs (CRUs) have been removed.
Strip cover Remove the strip cover (for mylar models) Make sure the following FRUs (CRUs) have been removed. “Remove the lower case” on page 30 Yoga Slim 7i Pro (14″, 5), Yoga Slim 7 Pro (14″, 5) Hardware Maintenance Manual...
Page 59
Number of screws M1.2 x L3.4 Step 2. Remove the strip cover. Figure 43. Remove the strip cover Go to https://support.lenovo.com/partslookup to look up the Lenovo part numbers of the following replacement part: Chapter 4 Removing a FRU or CRU...
“Remove the strip cover (for glass models)” on page 51 Step 1. Pull out two adhesive. Figure 44. Pull out two adhesive Step 2. Lift the LCD panel from the upper case. Yoga Slim 7i Pro (14″, 5), Yoga Slim 7 Pro (14″, 5) Hardware Maintenance Manual...
Figure 45. Lift the LCD panel Go to https://support.lenovo.com/partslookup to look up the Lenovo part numbers of the following replacement part: LCD panel Remove the LCD panel (for mylar models) Make sure the following FRUs (CRUs) have been removed. “Remove the lower case” on page 30 “Remove the upper case”...
Page 62
Replace the LCD bezel after removal. Step 2. Pull out two adhesive. Figure 47. Pull out two adhesive Step 3. Lift the LCD panel from the upper case. Yoga Slim 7i Pro (14″, 5), Yoga Slim 7 Pro (14″, 5) Hardware Maintenance Manual...
Figure 48. Lift the LCD panel Go to https://support.lenovo.com/partslookup to look up the Lenovo part numbers of the following replacement part: LCD panel Remove the EDP cable Make sure the following FRUs (or CRUs) have been removed. “Remove the lower case” on page 30 “Remove the upper case”...
Go to https://support.lenovo.com/partslookup to look up the Lenovo part numbers of the following replacement part: Microphone rubbers Remove the camera and cable Make sure the following FRUs (or CRUs) have been removed. “Remove the lower case” on page 30 “Remove the upper case” on page 44 “Remove the strip cover (for glass models)”...
Page 66
Figure 51. Remove the camera and cable Go to https://support.lenovo.com/partslookup to look up the Lenovo part numbers of the following replacement part: Camera and cable Yoga Slim 7i Pro (14″, 5), Yoga Slim 7 Pro (14″, 5) Hardware Maintenance Manual...