Table of Contents
Advertisement
IF THE SAFETY MECHANISM WAS ACTIVATED
G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G
IF THE SAFETY MECHANISM WAS ACTIVATED
If the safety mechanism is activated and this machine automatically stops, follow the steps below to
reset the machine.
If the safety mechanism is activated, the
1
screen shown at the right appears.
2
Press the
Disconnect the AC adapter from the machine and from the electrical
3
outlet.
Turn the needle position adjustment
4
dial (at the bottom of the machine) in
either direction as shown until the
thread cartridge is level.
1 Level position
2 Needle position adjustment dial
Press the thread cartridge release
5
button (
thread cartridge.
Turn on the machine and finish
6
embroidering.
CAUTION
•
After the safety mechanism has been activated, check that the thread cartridge, design
frame and pre-cut design fabric are not damaged.
- If the thread cartridge that was removed is broken or has a bent needle, dispose of the
cartridge. Use a new thread cartridge.
- If the design frame is damaged, use a different frame.
- If the pre-cut design fabric is damaged, use a new design fabric.
48
key to turn off the machine.
), and then remove the
1
2
Hide quick links:
Advertisement
Table of Contents
