hit counter script

A Call Recording; Saving Recording Call Data To The Recording Server - NEC UNIVERGE DT920 Series User Manual

Univerge sv9500
Hide thumbs Also See for UNIVERGE DT920 Series:
Table of Contents

Advertisement

A CALL RECORDING

SAVING RECORDING CALL DATA
TO THE RECORDING SERVER
You can save voice call data to Recording Server.
When a call is being recorded or when a recording error occurs,
LED of the key indicates the status of call recording if Record
key is assigned on a Programmable Feature Key. When a
recording starts, the recording confirmation tone (a tone to
indicate while the terminal is in a recording state) will be sent to
the target party at an interval of 15 seconds. However, the
recording confirmation tone can be disabled.
This feature and the followings are set at installation.
For details, contact the system administrator:
- playing recording confirmation tone
LED Display
The LED status while the call recording is executed are
explained below.
Recording Status
Call recording is stopped
Call recording is started
Call recording is in
standby
Call recording is disabled
for server error
To Record a Call Manually
Here explains the procedure for recording a call manually. Call
recording is started by pressing a Programmable Feature Key
where Call Recording feature is assigned. This Programmable
Feature Key is called the Record key
The Record key is assigned at installation.
For details, contact the system administrator.
1.
Press the Record key before starting a call or
while talking on the terminal. Then, the LED of the
Record key turned on.
■When you press the Record key while the call is being
recorded, the call recording is suspended and the call
recording status changes to standby mode. To resume the
call recording, press the Record key again.
■When the call recording starts, the recording confirmation
tone will be sent to the target party at an interval of 15
seconds. Please note that this setting can only be set up in
the Administrator access level.
2.
When the conversation finished by going on-
hook, the call recording is also finished.
LED Status
Turned off
Lighting Red
Lighting Green
Flashing Orange
(250ms cycle)
.
To Record a Call Automatically
When automatic call recording is set, call recording starts when
a user goes off-hook or presses the Speaker key. Going on-hook
or pressing the Speaker key again ends call recording. In this
way, a whole conversation can be recorded.
■The automatic call recording is set at installation.
For details, contact the system administrator.
■The range of recording voice data depends on the setting
of installation. For details, contact the system administrator.
The followings are the range of call recording to be set:
- voice call
- voice call and call progressive tone (tones from a
telephone)
82
A CALL RECORDING

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents

Save PDF