Beko WCB 77127 User Manual

Hide thumbs

Table Of Contents

WCB 77127

Washing machine

WCB 77107

WCB 77087

Table of Contents

Summary of Contents for Beko WCB 77127

Page 1 WCB 77127 Washing machine WCB 77107 WCB 77087...
Page 2: Warnings General Safety
1 Warnings • Keep the packaging materials out of reach General Safety of children or dispose them by classifying • Never place your machine on a carpet according to waste directives. covered ﬂoor. Otherwise, lack of airﬂow Intended use from below of your machine may cause •...
Page 3: Installation Removing Packaging Reinforcement
2 Installation Removing packaging reinforcement Tilt the machine to remove the packaging reinforcement. Remove the packaging reinforcement by pulling the ribbon. • If you are going to use your double water- Opening the transportation locks inlet machine as a single (cold) water-inlet Transportation safety bolts must be unit, you must install the stopper*, supplied removed before operating the washing with your machine to the hot water valve. machine! Otherwise, the machine will be • If you want to use both water inlets of the damaged! product, you can connect the hot water 1. Loosen all the bolts with a spanner until hose after removing the stopper and they rotate freely (“C”) gasket group from the hot water valve. 2. Remove transportation safety bolts by * Applies for the products supplied with a blind turning them gently. stopper group. 3. Fit the covers (supplied in the bag with the • Models with a single water inlet should not Operation Manual) into the holes on the be connected to the hot water tap. rear panel. (“P”) When returning the appliance to its place after maintenance or cleaning, care should be taken...
Page 4: Electrical Connection
Loading door Electrical connection The door locks during program operation and Connect the machine to an earthed outlet the Door Locked Symbol lights up. The door protected by a fuse of suitable capacity. can be opened when the symbol fades out. Important: • Connection should comply with national Detergents and softeners regulations. • The voltage and the allowed fuse Detergent Drawer protection are specified in the section The detergent drawer is composed of three “Technical Specifications”. compartments: • The specified voltage must be equal to The detergent dispenser may be in two your mains voltage. different types according to the model of your • Connection via extension cords or multi- machine. plugs should not be made. – (I) for prewash A damaged power cable must be replaced – (II) for main wash by a qualified electrician. - (III) siphon The appliance must not be operated unless – ( ) for softener it is repaired! There is the risk of electric shock! 3 Initial preparations for...
Page 5: Selecting A Program And Operating Your Machine Control Panel
4 Selecting a Program and Operating Your Machine Control panel Figure 1 1 - Spin Speed Adjustment Button 5 - Auxiliary Function Keys 2 - Time Delaying Button (+/-) 6 - Program Selection Knob 3 - Temperature Adjustment Button 7 - Display 4 - Start/Pause/Cancel Button 8 - On/Off Button Display symbols...
Page 6: Additional Programs
clothes on this program. In this program, your Main programs clothes will be washed for a longer time and Depending on the type of textile, the following an extra rinse cycle will be made compared to main programs are available: the “Cottons”...
Page 7 shown with “ ” symbols. Adjust the spin speed. Press “Start/Pause/Cancel” button. If you do not want to unload your clothes Program resumes. Your machine drains the immediately after the program, you may use water and spins your laundry. the rinse hold function in order to prevent your You can use no spin function in order to drain clothes become wrinkled in an anhydrous the water without spinning at the end of the...
Page 8 • No Spin Auxiliary functions You may use this program if you do not want Auxiliary function selection keys to spin your clothes at the end of cottons, Select the required auxiliary functions before synthetics, woolen or delicate programs. starting the program. •...
Page 9: Childproof Lock
5 Maintenance and cleaning cancelled or selected in accordance with the step the program is at. The door can be Detergent Drawer opened if the water level is suitable. Laundry Remove any powder residue buildup in the may be added / taken out by opening the drawer. To do this; door. 1. Press the dotted point on the siphon in the Child-proof lock softener compartment and pull towards You can protect the appliance from being you until the compartment is removed from tampered by children by means of the child- the machine. proof lock. In this case, no change can be made in the running program. This function protects the appliance from being tampered by children. In this case, all of the buttons are inactive except On/Off button; by On/Off button you can whether stop or resume (while child-lock on) the program of your machine. If more than a normal amount of water The machine is switched to child-lock by and softener mixture starts to gather in the pressing the 1st and 2nd auxiliary functions softener compartment, the siphon must be from the left for 3 sec. 1st auxiliary function cleaned. light will flash continuously. To deactivate the 2. Wash the dispenser drawer and the child-proof lock, press the same buttons for 3 siphon with plenty of lukewarm water in a sec.
Page 10 Draining any remaining water and by pulling out the plug at the end of the hose. If the amount of water to be drained cleaning the pump filter off is greater than the volume of the Your product is equipped with a filter system container, replace the plug, pour the water which ensures a cleaner water discharge that out, then resume the draining process. extends pump life by preventing solid items • After draining process is completed, such as buttons, coins and fabric fibers from replace the plug into the end of the hose clogging the pump propeller during discharge and fit the hose back into its place. of the washing water. If your product is not supplied with an • If your machine fails to drain the water, emergency drain hose, do the following as the pump filter may be clogged. You may shown in the figure below: have to clean it every 2 years or whenever it is plugged. Water must be drained off to clean the pump filter. In addition, water may have to be drained off completely in the following cases: • before transporting the machine (e.g. when moving house) • when there is the danger of frost In order to clean the dirty filter and discharge the water;...
Page 11: Solution Suggestions For Problems
6 Solution suggestions for problems Cause Explanation / Suggestion Program cannot be started or selected. • Machine may have switched to self • Reset your machine by pressing “Start/ protection mode due to an infrastructure Pause/Cancel” button for 3 seconds. (see, problem (such as line voltage, water Canceling a Program) pressure, etc.). There is water coming from the bottom of the machine. • Be sure the seals of the water inlet hoses are securely fitted. • There might be problems with hoses or • Tightly attach the drain hose to the tap. the pump filter. • Make sure that the pump filter is completely closed. Machine stopped shortly after the program started. • Machine can stop temporarily due to low • It will resume operating when the voltage is voltage. back to the normal level. It continuously spins. Remaining time does not count down. (For models with a display) • The automatic spin correction system might have been activated due to the unbalanced distribution of the laundry in the drum.
Page 12: Specifications
7 Specifications Models Maximum dry laundry capacity (kg) Height (cm) Width (cm) 56.5 56.5 Depth (cm) 56.5 Net Weight (kg) 230 V / 50Hz 230 V / 50Hz 230 V / 50Hz Electricity (V/Hz.) Total Current (A) 2200 2200 2200 Total Power (W) 1200 1000...

This manual is also suitable for:

Wcb 77107 Wcb 77087

Beko WCB 77127 User Manual

Table of Contents

Related Manuals for Beko WCB 77127

Summary of Contents for Beko WCB 77127

This manual is also suitable for:

Table of Contents