Chapter 7. Help And Support; Frequently Asked Questions - Lenovo ThinkPad P15 Gen 1 User Manual
Hide thumbs
Also See for ThinkPad P15 Gen 1:
- Hardware maintenance manual (147 pages) ,
- User manual (104 pages) ,
- Setup manual (10 pages)
Table of Contents
Advertisement
Chapter 7. Help and support
Frequently asked questions
How do I access Settings?
How do I turn off my computer?
What do I do if my computer
stops responding.
What do I do if I spill liquid on the
computer?
How do I enter the UEFI BIOS
menu?
How do I disable my trackpad?
Where can I get the latest device
drivers and UEFI BIOS?
© Copyright Lenovo 2020
Open the system menu drop down (top right) and click Settings.
From the system menu (top right) click
1. Press and hold the power button until the computer turns off. Then, restart
the computer.
2. If step 1 does not work:
• For models with an emergency reset hole: Insert a straightened paper clip
into the emergency reset hole to cut off power supply temporarily. Then,
restart the computer with ac power connected.
• For models without an emergency reset hole:
– For models with the removable battery, remove the removable battery
and disconnect all power sources. Then, reconnect to ac power and
restart the computer.
– For models with the built-in battery, disconnect all power sources.
Press and hold the power button for about seven seconds. Then,
reconnect to ac power and restart the computer.
1. Carefully unplug the ac power adapter and turn off the computer immediately.
The more quickly you stop the current from passing through the computer the
more likely you will reduce damage from short circuits.
Attention: Although you might lose some data or work by turning off the
computer immediately, leaving the computer on might make your computer
unusable.
2. Do not try to drain out the liquid by turning over the computer. If your
computer has keyboard drainage holes on the bottom, the liquid will be
drained out through the holes.
3. Wait until you are certain that all the liquid is dry before turning on your
computer.
Restart the computer. When the logo screen is displayed, press F1 to enter the
UEFI BIOS menu.
1. Open the system menu, and then click Settings ➙ Mouse & Touchpad.
2. In the Touchpad section, turn off the Touchpad control.
Use the Software application to check for updates. It should notify when new
firmware is available on LVFS (
, and then click Power Off.
https://fwupd.org/
).
37
- Quick Links:
- Left
- Uefi Bios
- Disable the Built-In Battery
- Beep Errors
Hide quick links:
Advertisement
Table of Contents
