Set, Change, And Remove A Password - Lenovo ThinkPad T15g Gen 2 User Manual
Hide thumbs
Also See for ThinkPad T15g Gen 2:
- Hardware maintenance manual (147 pages) ,
- User manual (104 pages) ,
- Setup manual (10 pages)
Table of Contents
Advertisement
Note: When you are prompted to enter the password, enter the correct supervisor password if a
supervisor password has been set, or enter the correct system management password if no supervisor
password has been set. Otherwise, you cannot change the configurations in the following steps.
2. Select Security ➙ Password ➙ System Management Password Access Control.
3. Follow the on-screen instructions.
If you have set both the supervisor password and the system management password, the supervisor
password overrides the system management password. If you have set both the system management
password and the power-on password, the system management password overrides the power-on
password.
Hard disk passwords
The hard disk password prevents unauthorized access to the data on the storage drive. When a hard disk
password is set, you are prompted to type a correct password each time you try to access the storage drive.
To set the hard disk password, select one of the following types:
• User hard disk password only
When a user hard disk password is set without a master hard disk password, the user must enter the user
hard disk password to access files and applications on the storage drive.
• Master hard disk password + User hard disk password
The master hard disk password is set and used by a system administrator. It enables the administrator to
access any storage drive in a system or any computer connected in the same network. The administrator
can also assign a user hard disk password for each computer in the network. The user of the computer
can change the user hard disk password as desired, but only the administrator can remove the user hard
disk password.
When prompted to enter a hard disk password, press F1 to switch between the master hard disk password
and user hard disk password.
Note: The hard disk password is not available when a Trusted Computing Group (TCG) Opal-compliant
storage drive and a TCG Opal management software program are installed in the computer, and the TCG
Opal management software program is activated.
Set, change, and remove a password
Before you start, print these instructions.
1. Restart the computer. When the logo screen is displayed, press F1 to enter the UEFI BIOS menu.
2. Select Security ➙ Password by using the arrow keys.
3. Select the password type. Then, follow the on-screen instructions to set, change, or remove a
password.
You should record all your passwords and store them in a safe place. If you forget any of your passwords,
any potential repair actions required are not covered under warranty.
What to do if you forget your power-on password
If you forget your power-on password, do the following to remove the power-on password:
• If you have set a supervisor password and remember it:
1. Restart the computer. When the logo screen is displayed, immediately press F1.
2. Type the supervisor password to enter the UEFI BIOS menu.
3. Select Security ➙ Password ➙ Power-On Password by using the arrow keys.
.
Chapter 4
Secure your computer and information
23
- Quick Links:
- Bottom View
- Uefi Bios
- M.2 Solid-State Drive
Hide quick links:
Advertisement
Table of Contents
