Replacing The Fuses; Maintaining The Headlights - Toro Workman GTX Operator's Manual
Electric utility vehicle
Hide thumbs
Also See for Workman GTX:
- Service manual (187 pages) ,
- Operator's manual (60 pages) ,
- Installation instructions manual (8 pages)
Table of Contents
Advertisement
Replacing the Fuses
There are 4 fuses in the electrical system; the other
slots are open for options. They are located under the
seat assembly behind a battery on the right side of
the machine
(Figure
42).
Main power
Electric relay
USB power point
Headlights
Optional lift kit—open
Horn—optional (standard on
international models only)
Figure 42
1. Fuse block
Maintaining the Headlights
Replacing the Headlight
1.
Disconnect the batteries; refer to
the Batteries (page
2.
Open the hood.
3.
Disconnect the electrical connector for the
harness from the connector of the lamp
assembly
(Figure
Disconnecting
39).
43).
10 A
20 A
5 A
10 A
15 A
30 A
1. Speed clip
2. Opening in the bumper
3. Adjustment screw
4.
Remove the speed clips that secure the
headlight to the headlight bracket
Note:
Retain all parts for installation of the new
g277605
headlight.
5.
Remove the headlight assembly by moving it
forward through the opening in the front bumper
(Figure
43).
6.
Install the new headlight through the opening in
the bumper
Note:
Ensure the adjustment posts are lined up
with the holes in the mounting bracket behind
the bumper.
7.
Secure the headlight assembly with the speed
clips that you removed in step 4.
8.
Connect the electrical connector for the harness
to the connector of the lamp assembly
43).
9.
Adjust the headlights to direct the beams to
the desired position, refer to
Headlights (page
40
Figure 43
4. Headlight
5. Harness electrical
connector
6. Lamp assembly
(Figure
(Figure
43).
Adjusting the
41).
g277621
43).
(Figure
Advertisement
Table of Contents
