LG 55SH7PE Owner's Manual
Hide thumbs
Also See for 55SH7PE:
- Owner's manual (111 pages) ,
- Manual (12 pages) ,
- Easy setup manual (12 pages)
Table of Contents
Advertisement
OWNER'S MANUAL
LG Digital
Signage
(MONITOR SIGNAGE)
Please read this manual carefully before operating your set and retain it for future reference.
43SH7PE
43SL5PE
49SH7PE
49SL5PE
55SH7PE
55SL5PE
43SL5E
32SE3KE
49SL5E
43SE3KE
55SL5E
49SE3KE
55SE3KE
Copyright © 2018 LG Electronics Inc. All Rights Reserved.
www.lg.com
Advertisement
Table of Contents
Related Manuals for LG 55SH7PE
Summary of Contents for LG 55SH7PE
- Page 1 (MONITOR SIGNAGE) Please read this manual carefully before operating your set and retain it for future reference. 43SH7PE 43SL5PE 43SL5E 32SE3KE 49SH7PE 49SL5PE 49SL5E 43SE3KE 55SH7PE 55SL5PE 55SL5E 49SE3KE 55SE3KE www.lg.com Copyright © 2018 LG Electronics Inc. All Rights Reserved.
-
Page 2: Table Of Contents
- Connecting the Stand ..........16 - Using the IR Receiver ...........18 - Portrait Layout ..............19 - Attaching and removing the LG Logo Bracket ... 20 - Installing on a Wall ............22 REMOTE CONTROL ....24 - Displaying the Device Name Connected to an Input Port ................26... -
Page 3: Safety Precautions
SAFETY PRECAUTIONS Please read these safety precautions carefully before using the product. WARNING If you ignore the warning message, you may be seriously injured or there is a possibility of accident or death. CAUTION If you ignore the caution message, you may be slightly injured or the product may be damaged. WARNING •... - Page 4 If you install the product in a place that does not meet the recommended conditions, this may cause serious damage to the product’s picture quality, life cycle, and appearance. Please check with LG or a qualified installer before installing. This caution applies to a place where there is an abundance of fine dust or oil mist, chemical substances are used, the temperature is very high or low, the humidity is very high, or the product is likely to remain turned on for a long period of time (airport and train station), failure to do so will invalidate the warranty.
-
Page 5: Precautions For Using Ac Adapter And Electrical Power
- If loosely connected, the poor connection may cause a fire or electric shock. • Be sure to use power cords and AC adapters provided or approved by LG Electronics, Inc. - The use of non-approved products may cause a fire or electric shock. - Page 6 • If you don’t intend to use the product for a long time, unplug the power cable from the product. - Covering dust can cause a fire, or insulation deterioration can cause electric leakage, electric shock or fire. • Fix the power cable completely. - If the power cable is not fixed completely, a fire can break out.
-
Page 7: Precautions For Moving The Product
Precautions For Moving the Product WARNING • Make sure to turn off the product. - You may be electrocuted or the product can be damaged. • Make sure to remove all cables before moving the product. - You may be electrocuted or the product can be damaged. •... -
Page 8: Precautions For Using The Product
Precautions For Using the Product WARNING • Do not disassemble, repair or modify the product at your own discretion. - Fire or electric shock accident can occur. - Contact the service center for check, calibration or repair. • When the display is to be left unattended for an extended period of time, unplug it from the wall outlet. •... -
Page 9: Mounting On A Wall
• Spray water onto a soft cloth 2 to 4 times, and use it to clean the front frame; wipe in one direction only. Too much moisture may cause staining. CHEMICALS WATER • Do not use products using high voltage around the Monitor. (e.g., a bug zapper) - Monitor may have malfunction as its electrical shock. -
Page 10: Licenses
LICENSES Supported licenses may differ by model. For more information of the licenses, visit www.lg.com. The terms HDMI and HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc. in the United States and other countries. -
Page 11: Assembly And Preparation
SuperSign Software & Manual - Downloading from the LG Electronics website. - Visit the LG Electronics website (http://partner.lge.com) and download the latest software for your model. • The warranty will not cover any damage caused by using the product in an excessively dusty environment. -
Page 12: Optional Accessories
43SH7PE washer) ST-432T 43SL5* 43SL5* 32SE3KE 10 mm 6 EA 43SE3KE 43SE3KE 43SH7PE/ 43SL5* 49SH7PE 49SH7PE 43SE3KE 49SL5* 49SL5* 2 EA 49SE3KE 49SE3KE 49SH7PE/ 49SL5* ST-492T 14 mm 8 EA 49SE3KE 55SH7PE 55SH7PE 55SL5* 55SL5* 55SH7PE/ 55SL5* 55SE3KE 55SE3KE 55SE3KE... - Page 13 OPS kit KT-OPSA Screws Connecting Cable Card (Easy Setup Guide) Power Cord OPS kit (Only for **SH7PE/**SL5PE model) KT-OPSD Screws Connecting Cable Card (Easy Setup Guide) Connecting Cable...
- Page 14 Media Player kit (It may not be supported depending on the model.) Screws Media Player Diameter 3.0 mm x Pitch 0.5 mm CD (Owner’s Manual)/ Cards MP500/ MP700 x Length 6mm Wi-Fi Dongle kit AN-WF500 NOTE • Cable holder/Cable tie may not be available in some areas or for some models. •...
-
Page 15: Parts And Buttons
Parts and Buttons The image may be different according to the model. Buttons • : Changes the input source. • : Accesses the main menus, or saves your input and exits the menus. • : Adjust the up and down. •... -
Page 16: Connecting The Stand
Connecting the Stand - For certain models only. - The image may be different according to the model. 32SE3KE... - Page 17 43/49/55SH7PE, 43/49/55SL5*, 43/49/55SE3KE...
-
Page 18: Using The Ir Receiver
Using the IR Receiver - The image may be different according to the model. This allows a remote control sensor to be placed in a custom location. Then that display can control other displays via an RS-232C cable. Install the IR receiver towards the front of the set. IR Receiver cable NOTE •... -
Page 19: Portrait Layout
Portrait Layout When installing in a portrait layout, rotate the monitor counterclockwise 90 degrees (when facing the screen). Using Kensington Lock (This is not available for all models.) The Kensington security system connector is located at the back of the monitor. For more information on installation and use of this system, refer to the manual provided with the Kensington security system or visit http://www.kensington.com. -
Page 20: Attaching And Removing The Lg Logo Bracket
LG Logo Bracket to the bottom rear of the monitor. LG Logo Bracket After removing the screw, remove the LG Logo Bracket. When re-attaching the LG Logo Bracket, repeat the process in reverse order. - Page 21 LG Logo Bracket to the bottom rear of the monitor. After removing the screw, remove the LG Logo Bracket. Attach the LG Logo Bracket with a screw, aligning it with the hole on the right side.
-
Page 22: Installing On A Wall
Screws which are longer than standard length may damage the inside of the monitor. A non-VESA standard screw may damage the product and cause the monitor to fall. LG Electronics is not liable for any accidents related to the use of non-standard screws. - Page 23 Disconnect the power cord before moving or installing the monitor to avoid risk of electric shock. • If you install the monitor on a ceiling or slanted wall, it may fall and result in injury. Use an authorized LG wall mount and contact your local dealer or qualified personnel to assist with the installation.
-
Page 24: Remote Control
REMOTE CONTROL The descriptions in this manual are based on the buttons on the remote control. Please read this manual carefully to use the monitor correctly. To install batteries, open the battery cover, place batteries (1.5 V AAA) matching terminals to the labels inside the compartment, and close the battery cover. To remove the batteries, perform the installation actions in reverse. - Page 25 Selects the Picture Mode. (HOME) Activates the Launcher. Enters the White Balance menu. (SETTINGS) Accesses the main menus or saves your input and exit menus. SuperSign menu key. Navigation Buttons Scrolls through menus or options. Selects menus or options and confirms your input. (BACK) Allows you to move back one step in the user interaction function.
-
Page 26: Displaying The Device Name Connected To An Input Port
Displaying the Device Name Connected to an Input Port Display which devices are connected to which external input ports. Access the Input list screen and press the red (input label) button on the remote control. You can assign an input label for every input except USB. NOTE •... -
Page 27: Making Connections
MAKING CONNECTIONS You can connect various external devices to your monitor. Change the input mode and select the external device you want to connect. For more information about external device connections, see the user manual provided with each device. Connecting to a PC Some of the cables are not provided. -
Page 28: Using The Input List
NOTE • For the best image quality, using the monitor with HDMI connection is recommended. • To comply with the specifications of the product, use a shielded interface cable with ferrite core, such as a D-sub 15-pin cable and DVI-D/HDMI cable. •... -
Page 29: Troubleshooting
TROUBLESHOOTING No image is displayed. Problem Action Is the product power cord connected? • Check if the power cord is correctly plugged into the power outlet. Does the “Invalid Format” message • The signal from the PC (Graphics card) is out of the vertical or appear? horizontal frequency range of the product. - Page 30 After-image appears on the product. Problem Action After-image appears when the product is • If you use a fixed image for a long time, the pixels may be damaged. turned off. Use the screen-saver function. • When a dark image is displayed on the screen after an image with high contrast (black and white or gray), this may cause image sticking.
- Page 31 CAUTION • Image sticking does not occur when using constantly changing images but may occur when using a fixed image for an extended period of time. Therefore, it is recommended that you use the instructions below to decrease the likelihood of image sticking occurring when using a fixed image.
-
Page 32: Product Specifications
PRODUCT SPECIFICATIONS The product specifications below may be changed without prior notice due to upgrade of product functions. “ ” refers to alternating current (AC), and “ ” refers to direct current (DC). LCD screen Screen type Thin Film Transistor (TFT) Liquid Crystal Display (LCD) Screen Video signal Maximum resolution... - Page 33 Head x Height x Depth) / 1102.2 mm x 696.8 mm x 219.6 mm / 17.6 kg Head + Stand Weight 55SH7PE 0.630 mm (H) x 0.630 mm (V) LCD screen Pixel pitch AC 100-240 V~ 50/60 Hz 2.3 A...
- Page 34 43SL5PE 0.4902 mm (H) X 0.4902 mm (V) LCD screen Pixel pitch AC 100-240 V~ 50/60 Hz 2.1 A Power Rated power On Mode: 70 W (Typ.) Power consumption Sleep Mode: ≤ 0.5 W Standby Mode: ≤ 0.5 W 969.6 mm x 563.9 mm x 54.0 mm / 10.5 kg Dimensions (Width Head x Height x Depth) /...
- Page 35 43SL5E 0.4902 mm (H) X 0.4902 mm (V) LCD screen Pixel pitch AC 100-240 V~ 50/60 Hz 0.9 A Power Rated power On Mode: 70 W (Typ.) Power consumption Sleep Mode: ≤ 0.5 W Standby Mode: ≤ 0.5 W 969.6 mm x 563.9 mm x 54.0 mm / 10.5 kg Dimensions (Width Head x Height x Depth) /...
- Page 36 32SE3KE 0.36375 mm (H) x 0.36375 mm (V) LCD screen Pixel pitch AC 100-240 V~ 50/60 Hz 0.8 A Power Rated power On Mode: 45 W (Typ.) Power consumption Sleep Mode: ≤ 0.5 W Standby Mode: ≤ 0.5 W 729.4 mm x 428.9 mm x 55.5 mm / 5.4 kg Dimensions (Width Head x Height x Depth) /...
- Page 37 RGB (PC) Support Mode Resolution Horizontal frequency (kHz) Vertical frequency (Hz) 720 x 400 31.468 70.8 640 x 480 31.469 59.94 800 x 600 37.879 60.317 1024 x 768 48.363 60.0 1280 x 720 44.772 59.855 1280 x 960 1152 x 864 57.717 59.934 63.981...
- Page 38 HDMI/ DVI-D /OPS (DTV) Support Mode Resolution Horizontal frequency (kHz) Vertical frequency (Hz) 480/60p 31.5 576/50p 31.25 720/50p 37.5 720/60p 1080/50i 28.1 1080/60i 33.75 1080/50p 56.25 1080/60p 67.5 NOTE • Resolutions available for the Input Label option in RGB, HDMI, DVI-D, OPS input modes. - PC resolutions: 640 x 480 / 60 Hz, 1280 x 720 / 60 Hz, 1920 x 1080 / 60 Hz - DTV resolutions: 480p, 720p, 1080p •...
- Page 39 • 43/49/55SL5E is not certified with EPA’s ENERGY STAR. This product qualifies for ENERGY STAR®. Changing the factory default configuration and settings or enabling certain optional features Make sure to read the Safety Precautions before using the and functionalities may increase product.