Bosch SHE53T56UC Operating Instructions Manual page 30
Hide thumbs
Also See for SHE53T56UC:
- Operating instructions manual (92 pages) ,
- Installation instructions manual (88 pages) ,
- Operating information manual (78 pages)
Table of Contents
Advertisement
en-us Operating the Dishwasher
Interrupting the wash cycle
9 CAUTION
Expansion (overpressure) may
cause the appliance door to
open and/or water to escape! If
the door was opened on an
appliance which has a hot water
connection or is heated, always
leave the door ajar for several
minutes and then close.
Press On/Off button (.
1.
The LED's go out. The wash cycle
is saved.
To continue the wash cycle, close
2.
the door and press On/Off button
( again.
Your dishwasher is protected
Note:
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Close the appliance door
and press the Start button P again.
Terminating the wash cycle
(Reset)
Press and hold Start button P
1.
w a s h c y c l e
T e r m i n a t i n g t h e
for approximately 3 seconds until
the display reads ‹:‹‚.
Wait about 1 minute while the
2.
dishwasher drains.
Press On/Off button (.
3.
You may now power the dishwasher
back on and begin a new cycle if
desired.
Changing the wash cycle
When the Start button ( has been
pressed, the wash cycle cannot be
changed. The only way a wash cycle
can be changed is by terminating the
wash cycle (Reset).
30
Child Lock (panel lock)*
The child lock will lock the panel
while the dishwasher is in operation
to prevent that a wash cycle is
interrupted unintenionally (e.g. by
children).
To set the panel lock:
Start the desired wash cycle.
1.
Hold down the button that says
2.
'Child Lock' underneath it for
approximately 3 seconds until the
display reads '–.
The panel lock is active.
'– will be indicated now if any button
is pressed and the program will not
be reset.
To deactivate the panel lock hold
down the button that says 'Child
Lock' underneath it for approximately
3 seconds until the display no longer
reads '–.
The panel lock is deactivated
automatically when the wash cycle is
completed. In case of a power
outage the panel lock will remain
active. The panel lock has to be
activated with each new wash cycle.
* optional feature which may or may
not be included with your
dishwasher.
Hide quick links:
Advertisement
Table of Contents
