Page 1
OWNER’S MANUAL LED LCD TV Please read this manual carefully before operating your set and retain it for future reference. LS38** P/NO : MFL67360823 (1206-REV00) www.lg.com Printed in Korea...
TABLE OF CONTENTS TABLE OF CONTENTS LICENSES OPEN SOURCE SOFTWARE NOTICE SAFETY INSTRUCTIONS INSTALLATION PROCEDURE ASSEMBLING AND PREPARING Unpacking Parts and buttons Lifting and moving the TV Setting up the TV - Attaching the stand Mounting on a table Mounting on a wall Tidying cables Not using the Desk-Type Stand Using the battery...
In addition to the source code, all referred license terms, warranty disclaimers and copyright notices are available for download. LG Electronics will also provide open source code to you on CD-ROM for a charge covering the cost of performing such distribution (such as the cost of media, shipping and handling) upon email request to opensource@lge.com.
SAFETY INSTRUCTIONS SAFETY INSTRUCTIONS Please read these safety precautions carefully before using the product. WARNING y Do not place the TV and remote control in the following environments: - A location exposed to direct sunlight - An area with high humidity such as a bathroom - Near any heat source such as stoves and other devices that produce heat - Near kitchen counters or humidifiers where they can easily be exposed to steam or oil...
Page 5
SAFETY INSTRUCTIONS y Do not plug too many electrical devices into a single multiple electrical outlet. Otherwise, this may result in fire due to over-heating. y Do not drop the product or let it fall over when connecting external devices. Otherwise, this may result in injury or damage to the product.
Page 6
SAFETY INSTRUCTIONS y Do not disassemble, repair or modify the product at your own discretion. Fire or electric shock accident can occur. Contact the service center for check, calibration or repair. y If any of the following occur, unplug the product immediately and contact your local service centre.
Page 7
SAFETY INSTRUCTIONS CAUTION y Install the product where no radio wave occurs. y There should be enough distance between an outside antenna and power lines to keep the former from touching the latter even when the antenna falls. This may cause an electric shock. y Do not install the product on places such as unstable shelves or inclined surfaces.
Page 8
SAFETY INSTRUCTIONS y Do not turn the product On/Off by plugging-in or unplugging the power plug to the wall outlet. (Do not use the power plug for switch.) It may cause mechanical failure or could give an electric shock. y Please follow the installation instructions below to prevent the product from overheating.
Page 9
SAFETY INSTRUCTIONS y When moving or unpacking the product, work in pairs because the product is heavy. Otherwise, this may result in injury. y Contact the service center once a year to clean the internal parts of the product. Accumulated dust can cause mechanical failure. y Refer all servicing to qualified service personnel.
INSTALLATION PROCEDURE / ASSEMBLING AND PREPARING NOTE y Image shown may differ from your TV. y Your TV’s OSD (On Screen Display) may differ slightly from that shown in this manual. y The available menus and options may differ from the input source or product model that you are using.
Page 11
ASSEMBLING AND PREPARING Remote control and batteries (AAA) (See p. 25) Owner’s manual Polishing cloth (Depending on model) Use this to remove dust from the cabinet. Power Cord Screw for assembly 8EA, M4 x 20 Screw for fixing (See p. 15) (See p.
Page 12
ASSEMBLING AND PREPARING NOTE y How to install Ferrite core to reduce electromagnetic interference in component Cables. - Install ferrite core close to TV input end of cables. (Black) [to an External device] [to the TV] 10 cm(+ / - 1 cm) [Cross Section of Ferrite Core] y Antenna Isolator Installation Guide...
ASSEMBLING AND PREPARING Parts and buttons Screen Remote control and intelligent sensors Power indicator Speakers Touch buttons SETTINGS INPUT Touch Button Description Scrolls through the saved programmes. Adjusts the volume level. OK ꔉ Selects the highlighted menu option or confirms an input. SETTINGS Accesses the main menu, or saves your input and exits the menus.
ASSEMBLING AND PREPARING Lifting and moving the TV y When transporting a large TV, there should be at least 2 people. y When transporting the TV by hand, hold the TV Please note the following advice to prevent the as shown in the following illustration. TV from being scratched or damaged and for safe transportation regardless of its type and size.
ASSEMBLING AND PREPARING Setting up the TV Attaching the stand Image shown may differ from your TV. CAUTION y When attaching the stand to the TV set, place the screen facing down on a cushioned table or flat surface to protect the M4 x 20 screen from scratches.
ASSEMBLING AND PREPARING Mounting on a table Securing the TV to a table Fix the TV to a table to prevent from tilting forward, 1 Lift and tilt the TV into its upright position on a damage, and potential injury. table.
When you attach the TV to other building materials, please contact qualified personnel. LG recommends that wall mounting be performed by a qualified professional installer. 10 cm 1 Insert and tighten the eye-bolts, or TV brackets and bolts on the back of the TV.
2 Fix the cable management firmly to the TV. y If you install the TV on a ceiling or slanted wall, it may fall and result in severe injury. Use an authorized LG wall mount and contact the local dealer or qualified personnel.
ASSEMBLING AND PREPARING Using the battery In the battery mode Attaching the battery 1 Open the battery compartment by sliding the battery latch at the back of the TV. 2 Check the grounding, align the battery with the bottom groove and then push it in until it clicks. 3 Close the compartment and lock the battery latch.
Page 20
The battery standby time given in the prompted to check the battery. manual is based on measurements taken by LG; the actual time may vary depending on usage. NOTE y Battery usage time may vary depending...
Page 21
Damage to the battery may result in fire or an explosion. y Always use a battery that is approved and certified by LG Electronics, Inc. Failure to do so may result in an explosion or fire. y Store the battery away from metallic objects, such as keys and paper clips.
MAKING CONNECTIONS MAKING Antenna connection CONNECTIONS Connect the TV to a wall antenna socket with an RF cable (75 Ω). Connect various external devices to the TV and switch input modes to select an external device. For more information of external device’s connection, refer to the manual provided with each device.
MAKING CONNECTIONS HDMI connection Component connection Transmits the digital video and audio signals from Transmits analog video and audio signals from an an external device to the TV. Connect the external external device to the TV. Connect the external device and the TV with the HDMI cable as shown. device and the TV with a component cable as shown.
MAKING CONNECTIONS USB connection Composite connection Connect a USB storage device such as a USB Transmits analog video and audio signals from an flash memory, external hard drive, or a USB external device to the TV. Connect the external memory card reader to the TV and access the My device and the TV with the composite cable as media menu to use various multimedia files.
REMOTE CONTROL REMOTE CONTROL The descriptions in this manual are based on the buttons on the remote control. Please read this manual carefully and use the TV correctly. To replace batteries, open the battery cover, replace batteries (1.5 V AAA) matching ends to the label inside the compartment, and close the battery cover.
USING THE USER GUIDE USING THE USER GUIDE User Guide allows you to more easily access the detailed TV information. 1 Press SETTINGS to access the main menus. User Guide OPTION > To set language 2 Press the RED button to access the Customer SETTING ...
MAINTENANCE / TROUBLESHOOTING MAINTENANCE Cleaning your TV Clean your TV regularly to keep the best performance and to extend the product lifespan. CAUTION y Make sure to turn the power off and disconnect the power cord and all other cables first. y When the TV is left unattended and unused for a long time, disconnect the power cord from the wall outlet to prevent possible damage from lightning or power surges.
SPECIFICATIONS SPECIFICATIONS Product specifications may be changed without prior notice due to upgrade of product functions. For the power supply and power consumption, refer to the label attached to the product. 32LS38** MODELS 32LS3800-TC 32LS380Y-TC 795.0 x 566.0 x 207.0 Dimensions With stand (mm) (W x H x D)
Page 29
SPECIFICATIONS Digital TV Analogue TV New Zealand, Television System DVB-T PAL/SECAM-B/G/D/K, PAL-I Singapore BG : VHF/UHF 1 to 69, CATV 01 to 47 Programme UHF 21 to 69 I : VHF/UHF 1 to 69, CATV 01 to 47 Coverage DK : VHF/UHF 1 to 69, CATV 01 to 47 Australia Television System DVB-T...
Page 30
SPECIFICATIONS HDMI-DTV supported mode Component port connecting information Component ports on the TV Y Resolution Horizontal Vertical Frequency Frequency (kHz) (Hz) Video output ports on DVD player 720x480 31.469 59.94 31.5 720x576 31.25 1280x720 37.5 44.96 59.94 Component Signal 480i/576i 1920x1080 33.72 59.94...
Page 32
080 100 5454 in Morocco 19960 in Egypt Other countries, Please contact our local dealer or log into http://www.lg.com Record the model number and serial number of (Only DTV) the TV. Refer to the label on the back cover and quote this information to your dealer when requiring any service.