Advertisement
Quick Links
Base Light Kit
Z Master
Model No. 144-0389
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
Note:
Determine the left and right sides of the machine from the normal operating position.
© 2020—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
4000 Series Riding Mower
Description
No parts required
No parts required
Light
Front bumper
Hex-washer head screw
No parts required
Headlight rocker switch
Wire harness
No parts required
No parts required
Register at www.Toro.com.
Form No. 3444-346 Rev A
Installation Instructions
Qty.
–
Prepare the machine.
–
Remove the existing front bumper.
1
1
Install the light and front bumper.
2
–
Remove the right side pod.
1
Install the headlight rocker switch.
1
Route and connect the wire harness.
–
Install the right side pod.
–
Connect the battery.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
Use
*3444-346*
Advertisement
Related Manuals for Toro 144-0389
Summary of Contents for Toro 144-0389
- Page 1 Form No. 3444-346 Rev A Base Light Kit Z Master ® 4000 Series Riding Mower Model No. 144-0389 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Prepare the machine.
-
Page 2: Preparing The Machine
Preparing the Machine Removing the Existing Front Bumper No Parts Required No Parts Required Procedure Park the machine on a level surface. Procedure Disengage the blade-control switch. Remove the 2 torx-head screws securing the front bumper (Figure Move the motion-control levers outward to the position. - Page 3 Secure the front bumper using the previously removed 2 torx-head screws (Figure Installing the Light and Front Bumper Parts needed for this procedure: Light Front bumper Hex-washer head screw g345491 Procedure Figure 3 1. Previously removed 2 2. Front bumper Secure the light to the light bracket using the 2 torx-head screw hex-washer head screws...
- Page 4 Install the headlight rocker switch into the control panel (Figure Orient the terminals on the rocker switch toward the rear of the machine. Installing the Headlight Orient the O position of the switch toward the front of the machine and the O position toward Rocker Switch the rear of the machine.
- Page 5 Routing and Connecting the Wire Harness Parts needed for this procedure: Wire harness Procedure Remove the cap from the auxiliary connector on the machine wire harness (Figure g345638 Figure 7 1. Auxiliary connector 2. Cap...
- Page 6 Route light kit wire harness along the right side of the machine frame and secure it using the 2 magnetic tie-mount wraps and 2 push-mount fasteners (Figure 8 Figure Ensure that you route the light kit wire harness underneath the deck-lift cross shafts as shown in Figure Connect the light kit wire harness to the headlight (Figure...
- Page 7 g345640 Figure 9 1. Connection to the headlight rocker 3. Right frame tube 5. Push-mount fastener switch 2. Magnetic tie-mount wraps 4. Deck-lift cross shaft 6. Fuel-tank support...
-
Page 8: Connecting The Battery
Installing the Right Side No Parts Required Procedure Secure the right side pod using the previously removed 4 shoulder screws (Figure Connecting the Battery No Parts Required Procedure Connect the negative-battery cable.