Removing An Expansion Module; Removing And Installing Power Supplies; Removing A Power Supply - Cisco 5000 Series Hardware Installation Manual
Platform and switch
Hide thumbs
Also See for 5000 Series:
- Product overview (992 pages) ,
- Administration manual (509 pages) ,
- Installation manual (317 pages)
Table of Contents
Advertisement
Removing and Installing Components
Removing an Expansion Module
To remove an expansion module from the Cisco Nexus 5548P switch or the Cisco Nexus 5000 Series
switch chassis, follow these steps:
Disconnect any network interface cables attached to the module.
Step 1
Loosen the captive screw on the module.
Step 2
Remove the module from the chassis by grasping the handle on the right side of the module and sliding
Step 3
the module part of the way out of the slot. Place your other hand under the module to support the weight
of it. Do not touch the module circuitry.
Place the module on an antistatic mat or antistatic foam if not immediately reinstalling it in another slot.
Step 4
Install a filler panel to keep dust out of the chassis and maintain consistent airflow if the slot will remain
Step 5
empty.
Removing and Installing Power Supplies
The Cisco Nexus 5548P switch or the Cisco Nexus 5000 Series switsh supports two front-end power
supplies, but it may be used with one power supply.
This section includes the following topics:
•
•
You can replace a faulty power supply while the system is operating provided the other power supply is
Note
functioning.
Removing a Power Supply
If you are using the Cisco Nexus 5548P switch or the Cisco Nexus 5000 Series switch with one power
Caution
supply, removing the power supply will cause the switch to shut down. If you are using two power
supplies and you remove one of them, the switch will continue to operate.
To remove a power supply, follow these steps:
Grasp the power supply handle with your left hand.
Step 1
Push against the release latch with your left thumb and slide the power supply out of the chassis. See
Step 2
Figure 3-14
from the Cisco Nexus 5020 switch, see figure .To remove a power supply from the Cisco Nexus 5010
switch, see figure
Place your right hand under the power supply to support it while you slide it out of the chassis.
Step 3
Cisco Nexus 5000 Series Hardware Installation Guide
3-26
S e n d c o m m e n t s t o n 5 k d o c s @ c i s c o . c o m
Removing a Power Supply, page 3-26
Installing a Power Supply, page 3-28
to remove a power supply for the Cisco Nexus 5548P switch. To remove a power supply
Chapter 3
Installing the Cisco Nexus 5500 Platform or 5000 Series Switch
OL-15902-01
Advertisement
Chapters
Table of Contents
