Maintaining Sfp+ Transceivers And Cables; Connecting To A Fibre Channel Port - Cisco 5000 Series Hardware Installation Manual
Platform and switch
Hide thumbs
Also See for 5000 Series:
- Product overview (992 pages) ,
- Administration manual (509 pages) ,
- Installation manual (317 pages)
Table of Contents
Advertisement
Chapter 4
Connecting the Switch
S e n d d o c u m e n t a t i o n c o m m e n t s t o n e x u s 5 k d o c s @ c i s c o . c o m
If the cable does not remove easily, ensure that any latch present on the cable has been released before
Caution
continuing.
To remove the cable, follow these steps:
Attach an ESD-preventive wrist strap and follow its instructions for use.
Step 1
Press the release latch on the cable, grasp the connector near the connection point, and gently pull the
Step 2
connector from the transceiver.
Insert a dust plug into the cable end of the transceiver.
Step 3
Insert a dust plug onto the end of the cable.
Step 4
Maintaining SFP+ Transceivers and Cables
SFP+ transceivers must be kept clean and dust-free to maintain high signal accuracy and prevent damage
to the connectors. Attenuation (loss of light) is increased by contamination and should be below 0.35 dB.
Consider the following maintenance guidelines:
•
•
•
•
•
•
Connecting to a Fibre Channel Port
This section applies to the Cisco Nexus 5500 Patform switches and the Cisco Nexus 5000 Series
Note
switches.
You can use an SFP transceiver to connect to an Fibre Channel port.
This section includes the following topics:
•
•
•
OL-15902-01
SFP+ transceivers are static sensitive. To prevent ESD damage, wear an ESD-preventive wrist strap
that is connected to the chassis.
Do not remove and insert a transceiver more often than is necessary. Repeated removals and
insertions can shorten its useful life.
Keep all optical connections covered when not in use. If they become dusty, clean before using to
prevent dust from scratching the fiber-optic cable ends.
Do not touch ends of connectors to prevent fingerprints and other contamination.
Clean regularly; the required frequency of cleaning depends upon the environment. In addition,
clean connectors if they are exposed to dust or accidentally touched. Both wet and dry cleaning
techniques can be effective; refer to your site's fiber-optic connection cleaning procedure.
Inspect routinely for dust and damage. If damage is suspected, clean and then inspect fiber ends
under a microscope to determine if damage has occurred.
Removing and Installing SFP+ Transceivers, page 4-4
Removing and Installing Cables into SFP+ Transceivers, page 4-6
Maintaining SFP+ Transceivers and Cables, page 4-7
Connecting to a Fibre Channel Port
Cisco Nexus 5000 Series Hardware Installation Guide
4-7
Advertisement
Chapters
Table of Contents
