Table of Contents
Advertisement
Available languages
Available languages
installation
instructions
Questions? Call 800.GE.CARES (800.432.2737) or visit our Website at: GEAppliances.com
In Canada, call 1.800.561.3344 or visit www.GEAppliances.ca
Before You Begin
read these instructions completely and carefully.
iMPorTAnT
•
instructions for local inspector's use.
iMPorTAnT
•
governing codes and ordinances.
• note to installer – Be sure to leave these
instructions with the Consumer.
• note to Consumer – Keep these
instructions for future reference.
• Skill level – Installation of this appliance
requires basic mechanical skills.
• Completion time – Approximately 1 hour
• W e recommend that two people install
this product.
• P roper installation is the responsibility
of the installer.
• P roduct failure due to improper installation
is not covered under the Warranty.
• You MUST use all supplied parts and use proper
installation procedures as described in these
instructions, and any separate kit instructions,
when installing this air conditioner.
eLeCTriCAL reQuireMenTS
Some models require a 115/120-volt a.c.,
60 Hz grounded outlet protected with
a 15-amp time delay fuse or circuit
breaker.
The 3-prong grounding plug minimizes the
possibility of electric shock hazard. If the wall
outlet you plan to use is only a 2-prong outlet,
it is your responsibility to have it replaced with
a properly grounded 3-prong wall outlet.
Some models require 230/208-volt a.c.,
protected with a time delay fuse or circuit
breaker. These models should be installed
on their own single branch circuit
for best performance and to prevent
overloading house or apartment wiring
circuits, which could cause a possible fire
hazard from overheating wires.
— Save these
— Observe all
Air Conditioner
CAuTion:
Do not, under any circumstances, cut or
remove the third (ground) prong from the
power cord.
Do not change the plug on the power cord
of this air conditioner.
Aluminum house wiring may present special
problems—consult a qualified electrician.
If the sill support bolts do not contact the
window sill, or if you have a window without
a sill, you must order accessory kit RAK87
to properly install this air conditioner. Call
800.626.2002 or visit GEAppliances.com.
TooLS You WiLL neeD
Phillips-head screwdriver
Adjustable wrench
Pencil
Level
P ower cord includes a current interrupter
device. A test and reset button is provided on
the plug case. The device should be tested on a
periodic basis by first pressing the TeST button
and then the reSeT button. If the TeST button
does not trip or if the reSeT button will not stay
engaged, discontinue use of the air conditioner
6
and contact a qualified service technician.
Flat-blade screwdriver
Ruler or tape measure
Scissors or knife
Advertisement
Table of Contents
