Related Manuals for Safe Fleet PRIME DESIGN OCM-3031
Summary of Contents for Safe Fleet PRIME DESIGN OCM-3031
- Page 1 OVER THE CAB 3–CROSSBAR MODULE PRIME DESIGN, A SAFE FLEET BRAND Address: 580 Opperman Drive, Eagan, MN 55123 ▪ Toll Free: 1.8.PRIME.RACK Fax: 651-552-1799 ▪ Email: info@primedesign.net ▪ Website: www.primedesign.net...
-
Page 2: Contents Overview
CONTENTS OVERVIEW Pickup Crossbar ............ (Qty 3) 67.00”, with caps Side Rail Tension Brace ........(Qty 4) Crossbar to Channel Connector ......(Qty 4) Pickup Rack End Stop ........... (Qty 6) LH Removable Crossbar Mount ......(Qty 1) RH Removable Crossbar Mount ......(Qty 1) Prime Design Limited Warranty. - Page 3 Tension Brace Mounting Bracket ......(Qty 2) HKT-0183 Removable Crossbar Hardware Kit M8 x 50MM (4X) M8 x 60MM Carriage Bolt (2X) Mounting Connector (4X) M8 Lock Nut (2X) Lock Washer (4X) " Flat Washer (6X) M8 Nut Bracket (4X) HKT-0182 Standard Crossbar Kit M8 x 20MM (8X) M8 x 30MM (8X)
- Page 4 ASSEMBLY INSTRUCTIONS NOTE: Channels in this Overview are shown for reference only. Specific channels and configurations are determined by Service Body size. CROSSBAR MOUNT BUILDS Set two Crossbar to Channel Connectors onto the Tension Brace Mounting Brackets as shown below, and install M8 Nut Install M8 Nut Brackets and Hardware from HKT-0183 Brackets and Hardware from HKT-0182.
-
Page 5: Installation
CROSSBAR MOUNTS Install the Mounting Connectors along with Hardware from HKT-0182 and HKT-0183 as shown in example below INSTALLATION (M8 x 60MM Carriage Bolts are used on all Connectors). Finger-tighten only until Step 3.2. Install Mounts into Channels as shown below. F r o s i d o t h... - Page 6 CROSSBARS Torque Front Mount Hardware to 90 in-lbs as shown. NOTE: Finger-tighten Mid and Rear Mounts only at this time. Set Crossbars into the Final Adjustments will be shown in your configuration’s Mounts as shown. FBM Manual. F r o R e a TENSION BRACE INSTALLATION CROSSBAR ADJUSTMENT...
- Page 7 Install Hardware from HKT-0182: Install Tensions Braces into the Channel sides 30MM Bolts,Flat Washers, and as shown below. Locknuts are used as shown. M8 x 30MM Flat Washers Locknut Tension Brace Mounting Bracket (Mid Mounts) Align Holes Torque all Tension Brace Hardware to 90 in-lbs LADDER STOPS...
- Page 8 USAM-OCM3031-US01 Rev-A 0220...