Troubleshooting - Yale MSW025-E Maintenance Manual
Steering mechanism
Hide thumbs
Also See for MSW025-E:
- Operating manual (98 pages) ,
- Maintenance manual (60 pages) ,
- Maintenance manual (14 pages)
Table of Contents
Advertisement
Gas Spring
2. Locate and drill a 7 mm (0.25 in.) access hole
through the center of the control handle tube, ap-
proximately 50 mm (2 in.) below the existing ac-
cess hole.
WARNING
Contents are under pressure. This process may
eject metal chips and oil.
PROBLEM
Steering is rough or difficult.
Steering handle does not return to
the vertical position.
6
3. Locate the gas spring inside the control handle
4. Clean up any discharged oil and dispose of in ac-
Troubleshooting
POSSIBLE CAUSE
Damaged, worn, or defective steer-
ing handle swivel bearing(s).
Steering handle swivel bearing(s)
need lubrication.
Bearing retaining nut torque incor-
rect.
Drive unit housing bearing (steer)
damaged.
Gas spring is weak or broken.
Gas spring ball stud broken or
loose.
through the newly drilled access hole and drill a
3 mm (0.125 in.) hole into the gas spring cylinder
shell to relieve pressure.
cordance with local regulations.
PROCEDURE OR ACTION
Replace bearings.
Lubricate or repack bearings.
Loosen retaining nut and tighten to
correct torque. See the section
Master Drive Unit 0630YRM1003.
Replace drive unit housing bearing
(steer).
Replace gas spring.
Retighten or replace gas spring
ball stud.
1600 YRM 1004
- Quick Links:
- Table of Contents
- Control Handle
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
