Numeric Error Codes - Lenovo ThinkPad X13 Yoga Gen 4 Hardware Maintenance Manual
Hide thumbs
Also See for ThinkPad X13 Yoga Gen 4:
- User manual (74 pages) ,
- Quick start manual (12 pages) ,
- Manual (10 pages)
Table of Contents
Advertisement
Numeric error codes
Symptom or error
0177
Bad SVP data, stop POST task—The checksum of the
supervisor password in the EEPROM is not correct.
0183
Bad CRC of Security Settings in EFI Variable. Enter the
ThinkPad Setup program. – The checksum of the Security
settings in the EFI Variable is not correct.
0187
EEAIA data access error - The access to EEPROM is
failed.
0188
Invalid RFID Serialization Information Area.
0189
Invalid RFID configuration information area - The
EEPROM checksum is not correct.
0190
Critical low-battery error
0191
System Security - Invalid Remote Change requested.
0199
System Security - Security password retry count
exceeded.
0270
Real Time Clock Error.
0271
Check Date and Time settings.
1802
Unauthorized network card is plugged in - Turn off and
remove the network card.
1820
More than one external fingerprint reader is attached.
Power off and remove all but the reader that you set up
within your main operating system.
2100
Detection error on Main HDD (SSD0) or Detection error on
Main HDD (HDD0)
2110
Read error on Main HDD (SSD0) or Read error on Main
HDD (HDD0)
2200
Machine Type and Serial Number are invalid.
2201
Machine UUID is invalid
32
ThinkPad X13 Gen 4 and ThinkPad X13 Yoga Gen 4 Hardware Maintenance Manual
FRU or action, in sequence
Replace the system board.
1. Run the ThinkPad Setup program. The settings
will be corrected automatically. Then save the
current settings by pressing F10.
2. Replace the system board.
Replace the system board.
Replace the system board.
Replace the system board.
1. Charge the battery.
2. Replace the battery.
1. Run the ThinkPad Setup program, and then save
current setting by pressing F10.
2. Replace the system board.
1. Run the ThinkPad Setup program. The retry count
will be reset. Then save the current settings by
pressing F10.
2. Replace the system board.
Have the computer serviced.
1. Run ThinkPad Setup to reset the time and date.
2. Replace the coin-cell battery and run the ThinkPad
Setup program to reset the time and date.
1. Remove the network card.
2. Replace the system board.
Remove all but the reader that you set up for the
authentication.
1. Reseat the M.2 solid-state drive.
2. Replace the M.2 solid-state drive.
3. Replace the system board.
1. Reseat the M.2 solid-state drive.
2. Replace the M.2 solid-state drive.
3. Replace the system board.
Have the computer serviced.
Replace the system board.
Advertisement
Table of Contents
