Table of Contents
Advertisement
General
The user must only carry out the maintenance and
service work described in this Operator's Manual. More
extensive work must be carried out by an authorized
service workshop.
Carburettor adjustment
Your Jonsered product has been designed and
manufactured to specifications that reduce harmful
exhaust fumes.
CarbControl
If the engine is equipped with CarbControl, manual
adjustment of the carburettor's H and L needles and the
T-screw no longer applies. Both needles and the T-screw
have been removed. CarbControl is a function that
adjusts the carburettor electronically, always resulting in
optimal adjustment.
WARNING! If the saw chain rotates while
!
idling, contact your servicing dealer. Do
not use the chain saw until it has been
properly adjusted or repaired.
Function
•
The carburettor controls the speed of the engine via
the throttle. Air/fuel is mixed in the carburettor. This
air/fuel mixture is adjustable.
•
The automatic adjustment of the carburettor means
that the engine is adapted to local conditions, e.g. the
climate, altitude, petrol and the type of 2-stroke oil.
This function is controlled by CarbControl.
Engine adjustment
The following steps should be taken when the chain saw
is started for the first time or when outside circumstances
change (fuel, altitude, air filter etc.):Start the engine.
Accelerate the engine and saw a number of cuts in a thick
log (3-5 min.). The chain saw must be run (8,000 - 12,000
rpm) the entire time so that the carburettor can adjust
itself.
When working for long periods in young forest with small
dimensions and/or much limbing, the cutting process
must be performed more frequently often on thicker logs.
Cutting must be done with with full throttle under load.
This is so that the carburettor's automatic control function
can be activated.
Conditions
NOTE! The ignition system includes an in-built speed
limiter. When the speed governor is activated, you will get
the same sound experience as when the chain saw 4-
cycles.
30 – English
MAINTENANCE
Checking, maintaining and
servicing chain saw safety
equipment
Note! All service and repair work on the machine
demands special training. This is especially true of the
machine's safety equipment. If your machine fails any of
the checks described below we recommend that you
take it to your service workshop.
Chain brake and front hand guard
Checking brake band wear
Brush off any wood dust, resin and dirt from the chain
brake and clutch drum. Dirt and wear can impair
operation of the brake.
Regularly check that the brake band is at least 0,6 mm
thick at its thinnest point.
Checking the front hand guard
Make sure the front hand guard is not damaged and that
there are no visible defects such as cracks.
Move the front hand guard forwards and back to make
sure it moves freely and that it is securely anchored to the
clutch cover.
Advertisement
Table of Contents
