Table of Contents
Advertisement
Remove the power board
Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 30
"Remove the heat sink" on page 35
Step 1.
Disconnect the power board cable from the power board.
Figure 18. Disconnect the power board cable from the power board
Step 2.
Remove two screws and then open the hinge.
Figure 19. Remove two screws and then open the hinge
Screw specifications
M2.5 x L5
Step 3.
Remove one screw and then remove the power board.
38
Hardware Maintenance Manual
Number of screws
2
Advertisement
Table of Contents
