Table of Contents
Advertisement
Figure 40. Removing the BOSS card
Next steps
1.
Install the BOSS
card.
Installing the BOSS card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
1. Align the BOSS card at angle of 45 degrees with the connector on the M.2 BOSS module.
2. Press the BOSS card into the SATA connector until firmly seated in place.
3. Push down the BOSS card and using Phillips #1 screwdriver, secure the BOSS card to the module.
80
Installing and removing system components
Safety instructions
on page 46 section.
Before working inside your system
on page 46.
Advertisement
Table of Contents
