Table of Contents
Advertisement
aus Operating the appliance
1
Operating the
appliance
C hanging the settings
O p e r a t i n g t h e a p p l i a n c e
The dishwasher has been preset with
certain settings for your convenience.
You can change these factory settings.
Change the setting as follows:
Open the door.
1.
Switch on ON/OFF switch (.
2.
Press Info button {8 for 3
3.
seconds until the following text is
indicated on the display window at
the top @:
Scroll with < >
Set with - +
Leave with Setup 3 sec.
Keep pressing button >)" until the
4.
required setting is indicated on the
display window at the top @.
Make the setting with setting buttons
5.
+ -P.
Press and hold the Info button {
6.
8 for 3 seconds.
The chosen setting has now been
stored.
Tip: If you change several settings, first
make all changes in succession. Now
press the Info button { 8 for
3 seconds. This saves all set values in
the appliance.
28
AquaSensor *
* depending on the features of your
A q u a S e n s o r
dishwasher
The Aqua sensor is an optical
measuring device (light barrier) which
measures the turbidity of the rinsing
water.
The AquaSensor is used according
to the programme. If the AquaSensor is
active, "clean" rinsing water can be
transferred to the next rinse bath and
water consumption can be reduced by
3–6 litres. If the turbidity is greater,
the water is drained and is replaced
with fresh water. In the automatic
programmes the temperature
and running time can also be adjusted
to the degree of soiling.
Zeolith drying
:
Warning
Z e o l i t h d r y i n g
Risk of burns from touching the blow
opening 1R!
Never touch the blow opening. The blow
opening becomes hot and, furthermore,
any damage will result in a chargeable
callout by customer service.
¼
Advertisement
Table of Contents
