Intended use Delivery Intended use 1. Check the packaging and I n t e n d e d u s e This appliance is intended for dishwasher immediately for use in the home and damage caused in transit. Do the home environment. not switch on a damaged appliance, but contact your Use the dishwasher...
Page 6
Safety instructions The electrical connection If you cannot obtain any conditions must correspond information from with the specifications the manufacturer, you must on the dishwasher rating not install the dishwasher plate 9J. above or below these appliances. If the power cord of this appliance is damaged, If you install a microwave it must be replaced with...
Safety instructions In daily use Warning Risk of injury! Read and observe the safety information and instructions To prevent injuries, e.g. for use on the packaging caused by stumbling, open for cleaning and rinsing agents. the dishwasher only briefly in order to load and unload the dishwasher.
Page 8
Safety instructions When opening and closing Warning the door on an eye-level Risk of scalding! appliance, ensure that Open the door carefully when children do not become the programme is still running. jammed or crushed between There is a risk of hot water the appliance door and the spraying out of the appliance.
Protection of the environment Protection of the Getting to know your environment appliance i o n P r o t e c t o f t e n v i r o n m e n t G e t t i t o k n o w y o u r a p p l i a n c...
Getting to know your appliance Appliance interior Selecting language The language in the display window )2 1" Interior light * can be set from p: , to p: . German 1* Top basket (Deutsch) is the factory setting. 12 Knife shelf * Language Setting 1: Top spray arm...
Water softening system/Special salt To change the language: Water softening 1. Open the door. system/Special salt 2. Switch on ON/OFF switch (. 3. Hold down programme button # W a t e r s o f t e n i s y s t e m / S p e c i s a l t and press START button )"...
Water softening system/Special salt To change the setting: Using special salt 1. Press programme button 3. Always refill with special salt Each time the button is pressed, the immediately before set value increases by one level; switching on the appliance. This when the value of : has been ensures that overrun special salt...
Rinse aid Using detergents with salt Rinse aid component D e t e r g e n t s w i t h s a l t c o m p o n e n t R i n s e a i d As soon as the low rinse-aid indicator If combined detergents with a salt...
Utensils 3. Close cover until it clicks shut. Switching off rinse aid refill 4. To prevent excessive foam formation indicator during the next rinse cycle, remove any rinse aid which has run over with If the use of combined detergents with a a cloth.
Utensils Glass and utensil damage Unloading the dishwasher Causes: To prevent water from dripping off the upper basket onto the utensils in the Glass type and glass production lower basket, it is recommended process. to empty the appliance from the bottom Chemical composition of the detergent.
Utensils Note Utensils must not be placed above the Heavily soiled utensils (pans) should tablet collecting tray 1B. These may be placed in the bottom basket. The block the lid of the detergent dispenser more powerful spray jet provides and prevent it from opening fully. a better dishwashing result.
Utensils Chopstick basket* E tagere * C h o p s t i c k b a s k e t E t a g e r e *depending on the model The etagere and the space underneath can be used for small cups and glasses Chopsticks up to a length of 24 cm can or for larger items of cutlery, such as be placed in the chopstick basket.
Utensils Small accessories holder * A djusting the height of the S m a l l a c c e s s o r i e s h o l d e r A d j u s t i n g t h e h e i g h t o f t h e b a s k e t basket * * depending on model Light-weight plastic accessories, e.g.
Page 19
Utensils Top basket with side levers 1. Pull out the top basket 1* out. 2. To lower the basket, press in the left and then the right lever on the outside of the basket. In doing so, hold the sides of the basket along the upper edge to prevent it from suddenly dropping.
Detergent Adding detergent Detergent 1. If the detergent dispenser 9: is still D e t e r g e closed, press the lock 9B to open You can use tablets as well as powder the detergent dispenser. or liquid detergents for dishwashers, but never use washing up liquid.
Detergent Notes If the utensils are only lightly soiled, You will obtain optimum rinsing slightly less than the indicated amount and drying results by using solo of detergent is usually adequate. detergents and applying salt and rinse aid separately. Suitable detergents and care products If programmes are short, tablets can be purchased online may not have full cleaning effect...
Overview of programmes Overview of programmes p r o g r a m m e s O v e r v i e w o f The max. possible number of programmes is illustrated in this overview. The corresponding programmes and their arrangement can be found on the fascia.
Additional options § Programme selection Half load * H a l f l o a d You can select a suitable programme If you have only a few items to wash according to the type of utensils and (e.g. glasses, cups, plates), you can degree of soiling.
Operating the appliance Zeolith drying Operating the appliance The appliance features a Zeolith container Zeolith is a mineral which can O p e r a t i i a n c e t h e a p p l store moisture and heat energy and release them again.
Operating the appliance Remaining running time Timer programming display You can delay the start of the programme in 1 hour steps up to When the programme is selected, the 24 hours. remaining running time of the programme is indicated on the digital 1.
Operating the appliance End of programme Automatic switch off after end of programme or interior light* A u t o m a t i c s w i t c h o f f / i n t e r i o r l i g h t The programme ends when the value appears on the digital display 8 * depending on model...
Operating the appliance To change the setting: Interrupting the programme 1. Press programme button 3. 1. Open the door. Each time the button is pressed, 2. Switch off ON/OFF switch (. the set value increases by one level; when the value of : has been The LEDs go out.
Cleaning and maintenance Changing the programme Cleaning and maintenance When the START button )" has been pressed, the programme cannot be C l e a n i a n d m a i n t e n a n c e changed.
Cleaning and maintenance Warning – Health hazard Never use other domestic detergents, e.g. containing chlorine! Special salt and rinse aid As soon as the refill indicators are lit on the fascia H and P or there is a request in the display window )2, salt and/or rinse aid should be topped up.
Fault, what to do? Spray arms Fault, what to do? F a u l t , w h a t d o ? Limescale and contaminants in the rinsing water may block nozzles and Experience has shown that you can bearings on the spray arms 1: and rectify most faults which occur in daily operation yourself.
Fault, what to do? Waste water pump Large food remnants or foreign objects which were not captured by the filters may block the waste water pump. The rinsing water will then be above the filter. Warning – Risk of cuts! When cleaning the waste water pump, ensure that you do not injure yourself on pieces of broken glass or pointed...
Fault, what to do? Fault table Fault Cause Remedial action “Check water supply” Supply hose kinked. Install supply hose without kinks. display @ lights up. Tap turned off. Turn the tap on. Tap jammed or calcified. Turn the tap on. Flow rate must be min.
Page 33
Fault, what to do? Fault Cause Remedial action A different error code is A technical fault has probably Switch off appliances with the ON/OFF switch (. After a short time restart the indicated on the digital occurred. display. appliance. to : If the problem recurs, turn off the tap and pull out the mains plug.
Page 34
Fault, what to do? Fault Cause Remedial action Utensils not dry. No or too little rinse aid in the Refill rinse aid. dispenser. Programme selected without Select programme with drying (see drying. “Overview of programmes”, “Programme sequence”). Water collecting in depressions Arrange utensils in a sloping position, on the utensils and cutlery.
Page 35
Fault, what to do? Fault Cause Remedial action Food remnants on the Utensils placed too closely Arrange utensils with adequate clearance utensils. together, utensils basket between them ensuring that the spray jets overfilled. can reach the surface of the utensils. Prevent contact points.
Page 36
Fault, what to do? Fault Cause Remedial action Water stains on plastic Droplet formation on plastic Use a more intensive programme (more parts. surface is physically unavoidable. water changes). After drying, water stains are Arrange utensils in a sloping position. visible.
Page 37
Fault, what to do? Fault Cause Remedial action Coloured (blue, yellow, Film formation consisting of Can be partly removed with machine brown), difficult to remove ingredients from vegetables (e.g. cleaner or by mechanical cleaning. Coatings to non-removable coatings cabbage, celery, potatoes, are harmless.
Page 38
Fault, what to do? Fault Cause Remedial action Initial or existing, Glasses not dishwasher-proof, Use dishwasher-proof glasses. irreversible clouding of only suitable for dishwasher. Avoid long steam phase (standing time after glass. wash cycle ends). Use wash cycle at lower temperature. Set water softening system according to the water hardness (if required one setting lower).
Page 39
Fault, what to do? Fault Cause Remedial action Detergent residue in the Spray arms blocked by utensils, Ensure that the spray arms can rotate freely. detergent dispenser or in therefore detergent is not rinsed the tablet collecting tray. out. The detergent dispenser was Pour detergent into the dry detergent damp when filled.
Customer service Customer service Installation and connection C u s t o m e r s e r v i c e If you are unable to rectify the fault, l a t i o n I n s t a l a n d c o n n e c t i please contact your customer service.
Installation and connection Delivery Installation Your dishwasher has been checked The required installation dimensions can thoroughly in the factory to ensure that it be found in the installation instructions. is in working order. This may cause Level the appliance with the aid of the small water stains.
Installation and connection Drinking water connection Warm water connection * W a r m w a t e r c o n n e c t i o n 1. Fasten the drinking water connection * depending on model to the tap according The dishwasher can be connected to the installation instructions using to cold or hot water up to max.
Installation and connection Electrical connection Removing the appliance Connect the appliance to an Also observe alternating current only, ranging from the sequence of worksteps here. 220 V to 240 V and 50 Hz or 60 Hz 1. Disconnect the appliance from via a correctly installed socket with the power supply.
Installation and connection Transportation Protection against frost P r o t e c t i o n a g a i n s t f r o s t ( E m p t y i n g t h e a p p l i a n c e ) Empty the dishwasher and secure loose If the appliance is in a room where there parts.
Page 46
*9001053423* 9001053423 en (9412_*) 640TV...