Table of Contents
Advertisement
Chapter 1 Maintenance
5.4
Problem of Starting OS
[?]
Unable to start OS
Have the settings of the RAID controller changed?
→ Specify the correct settings with RAID Configuration Utility (Off-line Utility or LSI Software RAID
Configuration Utility).
Is the RAID controller found by POST?
→ Be sure to connect the RAID controller correctly and retry.
Is the RAID controller installed firmly straight into the PCI slot?
→ Install the RAID controller properly.
Is the RAID controller mounted on the PCI slot for which the mounting is restricted?
→ Check the mounting restrictions of the server and then mount the RAID controller on the correct slot.
Are the hard disk drives properly installed?
→ Install the hard disk drives properly.
Is the SAS cable connected to the hard disk drive correctly?
→ Connect the SAS cable properly.
Is the EXPRESSBUILDER DVD inserted?
→ Remove the EXPRESSBUILDER DVD and restart.
Is a cartridge inserted into N8151-86 with built-in RDX (USB)?
→ Either remove the cartridge or change the boot order in BIOS Setup.
Is a disk array unit connected to the PCI card?
→ Change the boot order from BBS Priorities of the BIOS Setup Utility.
Express5800/R120g-2E, T120g Maintenance Guide
5. Troubleshooting
35
Advertisement
Table of Contents
