hit counter script

Display Assembly; Removing The Display Assembly - Dell NOT21991 Owner's Manual

Table of Contents

Advertisement

Steps
1. Align and place the power-adapter port in the slot on the palm-rest and keyboard assembly.
NOTE:
The power-adapter port is secured in place by the right display hinge. There is no screw, tape, or adhesives
securing the power-adapter port to the palm rest. As a result, technicians should take note of whether the power-
adapter port has fallen out of the computer during subsequent removal procedures.
2. Connect the power-adapter port cable to the connector on the system board.
3. Close the right display hinge downwards to align the screw holes on the right display hinge to the screw holes on the system
board and the palm-rest and keyboard assembly.
4. Replace the two screws (M2.5x5) to secure the right display hinge to the system board and the palm-rest and keyboard
assembly.
Next steps
1. Install the
base
cover.
2. Follow the procedure in

Display assembly

Removing the display assembly

CAUTION:
The information in this section is intended for authorized service technicians only.
CAUTION:
The maximum operating angle for the display-panel hinge is 135 degrees.
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
wireless
card.
NOTE:
This procedure applies only to systems shipped with a plastic chassis.
78
Removing and installing Field Replaceable Units (FRUs)
After working inside your
Before working inside your
computer.
computer.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vostro 15 3530P112f

Table of Contents