Table of Contents
Advertisement
Screw specifications
M2.0 x L2.0
Go to
https://support.lenovo.com/partslookup
part:
Heat sink
Remove the fan
Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 58
Step 1.
Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2.
Disconnect the fan cable from the system board and release the fan cable from the cable guide.
Figure 60. Disconnect the fan cable from the system board and release the fan cable from the cable guide
Step 3.
Remove two screws and then remove the fan.
Figure 61. Remove two screws and then remove the fan
66
Hardware Maintenance Manual
Number of screws
5
to look up the Lenovo part number of the following replacement
Advertisement
Table of Contents
