hit counter script

LG LCFS22EX Series Owner's Manual page 39

Bottom freezer refrigerator
Hide thumbs Also See for LCFS22EX Series:
Table of Contents

Advertisement

Available languages

Available languages

Problem
Refrigerator was recently installed or
icemaker recently connected.
Icemaker not turned on.
The ice detecting sensor is obstructed.
The refrigerator is not connected to a
Icemaker is not
water supply or the supply shutoff valve is
making ice.
not turned on.
Icemaker shutoff (arm or sensor)
obstructed.
Reverse osmosis water filtration system
is connected to your cold water supply.
New installation or water line recently
connected.
The dispenser panel is locked.
The dispenser is not set for water
dispensing.
Refrigerator or freezer doors are not
closed properly.
Not dispensing
water.
Water filter has been recently removed or
replaced.
Tubing connecting refrigerator to house
supply valve is kinked.
The house water supply is not connected,
the valve is not turned on fully, or the
valve is clogged.
TROUBLESHOOTING GUIDE
Possible Causes
3
Solutions
It may take up to 24 hours for each compartment
to reach the desired temperature and for the
icemaker to begin making ice.
Locate the icemaker ON/OFF switch and confirm
that it is in the ON (I) position.
Foreign substances or frost on the ice-detecting
sensor can interrupt ice production. Make sure
that the sensor area is clean at all times for
proper operation.
Connect refrigerator to the water supply and turn
the water shutoff valve fully open.
If your icemaker is equipped with an ice shutoff
arm, make sure that the arm moves freely. If your
icemaker is equipped with the electronic ice
shutoff sensor, make sure that there is a clear
path between the two sensors.
Reverse osmosis filtration systems can reduce
the water pressure below the minimum amount
and result in icemaker issues. (Refer to the Water
Pressure section.)
Dispense 2.5 gallons (9 liters) of water (flush for
approximately 5 minutes) to remove trapped
air and contaminates from the system.
Do not dispense the entire 2.5 gallon (9 liters)
amount continuously. Depress and release the
dispenser pad for cycles of 30 seconds ON and
60 seconds OFF.
Press and hold the Control Lock button for
three seconds to unlock the control panel and
dispenser.
The dispenser can be set for ice or water. Make
certain that the control panel is set for the proper
operation. Press the Ice/Water Select button on
the control panel.
Water will not dispense if any of the refrigerator
doors are left open.
After the water filter is replaced, dispense 2.5
gallons of water (flush for approximately
5 minutes) to remove trapped air and
contaminates from the system. Do not dispense
the entire 2.5 gallon (9 liters) amount
continuously. Depress and release the dispenser
pad for cycles of 30 seconds ON and 60
seconds OFF.
The tubing can kink when the refrigerator is
moved during installation or cleaning resulting
in reduced water flow. Straighten or repair the
water supply line and arrange it to prevent future
kinks.
Connect refrigerator to the water supply and turn
the water shutoff valve fully open.
If the problem persists, it may be necessary to
contact a plumber.

Advertisement

Chapters

Table of Contents
loading

Table of Contents