Table of Contents
Advertisement
Operation
Before Operation
Before Operation Safety
General Safety
•
Never allow children or untrained people to
operate or service the machine. Local regulations
may restrict the age of the operator. The owner
is responsible for training all operators and
mechanics.
•
Become familiar with the safe operation of the
equipment, operator controls, and safety signs.
•
Shut off the engine, remove the key, and wait
for all movement to stop before you leave the
operator's position. Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
•
Know how to stop the machine and shut off the
engine quickly.
•
Check that operator-presence controls, safety
switches, and guards are attached and functioning
properly. Do not operate the machine unless they
are functioning properly.
•
Before mowing, always inspect the machine to
ensure that the blades, blade bolts, and cutting
assemblies are in good working condition.
Replace worn or damaged blades and bolts in sets
to preserve balance.
•
Inspect the area where you will use the machine
and remove all objects that the machine could
throw.
•
This product generates an electromagnetic field.
If you wear an implantable electronic medical
device, consult your health care professional
before using this product.
Fuel Safety
•
Use extreme care in handling fuel. It is flammable
and its vapors are explosive.
•
Extinguish all cigarettes, cigars, pipes, and other
sources of ignition.
•
Use only an approved fuel container.
•
Do not remove the fuel cap or fill the fuel tank
while the engine is running or hot.
•
Do not add or drain fuel in an enclosed space.
•
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or other appliance.
•
If you spill fuel, do not attempt to start the engine;
avoid creating any source of ignition until the fuel
vapors have dissipated.
Performing Daily
Maintenance
Before starting the machine each day, perform
the Each Use/Daily procedures listed in
Maintenance Checklist (page
Checking the Air Pressure
in the Tires
Service Interval: Before each use or daily
Front and rear tires air pressure specification: 150
kPa (21 psi).
DANGER
Low tire pressure decreases machine side-hill
stability. This could cause a rollover, which
may result in personal injury or death.
Do not under-inflate the tires.
Check the air pressure in the front and rear tires. Add
or remove air as needed to set the air pressure in the
tires to the tire air pressure specification.
Important:
Maintain pressure in all tires to
ensure a good quality of cut and proper machine
performance.
Check the air pressure in all the tires before
operating the machine.
24
Daily
41).
Figure 16
g001055
Advertisement
Table of Contents
