Default Port Security Configuration; Port Security Guidelines And Restrictions; Configuring Port Security - Cisco 4500M Software Manual
Software guide
Hide thumbs
Also See for 4500M:
- Command reference manual (578 pages) ,
- Hardware installation and maintenance manual (143 pages) ,
- Upgrade manual (24 pages)
Table of Contents
Advertisement
Chapter 32
Configuring Port Security
Default Port Security Configuration
Table 32-1
Table 32-1 Default Port Security Configuration
Feature
Port security
Maximum number of secure MAC addresses
Violation mode
Aging
Aging type
Static Aging
Sticky
Port Security Guidelines and Restrictions
Follow these guidelines when configuring port security:
•
•
•
•
Configuring Port Security
These sections describe how to configure port security:
•
•
OL-6696-01
shows the default port security configuration for an interface.
A secure port cannot be a trunk port.
A secure port cannot be a destination port for Switch Port Analyzer (SPAN).
A secure port cannot belong to an EtherChannel port-channel interface.
A secure port and static MAC address configuration are mutually exclusive.
Configuring Port Security on an Interface, page 32-4
Configuring Port Security Aging, page 32-6
Default Port Security Configuration
Default Setting
Disabled on a port
1
Shutdown. The port shuts down when the maximum
number of secure MAC addresses is exceeded, and an
SNMP trap notification is sent.
Disabled
Absolute
Disabled
Disabled
Software Configuration Guide—Release 12.2(25)EW
32-3
Advertisement
Table of Contents
