Configuring Etherchannel; Configuring Layer 3 Etherchannels - Cisco 4500M Software Manual
Software guide
Hide thumbs
Also See for 4500M:
- Command reference manual (578 pages) ,
- Hardware installation and maintenance manual (143 pages) ,
- Upgrade manual (24 pages)
Table of Contents
Advertisement
Configuring EtherChannel
•
•
Configuring EtherChannel
These sections describe how to configure EtherChannel:
•
•
•
•
•
•
Ensure that the interfaces are configured correctly. (See the
Note
and Restrictions" section on page
Configuring Layer 3 EtherChannels
To configure Layer 3 EtherChannels, create the port-channel logical interface and then put the Ethernet
interfaces into the port-channel.
These sections describe Layer 3 EtherChannel configuration:
•
•
Creating Port-Channel Logical Interfaces
To move an IP address from a physical interface to an EtherChannel, you must delete the IP address from
Note
the physical interface before configuring it on the port-channel interface.
Software Configuration Guide—Release 12.2(25)EW
17-6
After you configure an EtherChannel, any configuration that you apply to the port-channel interface
affects the EtherChannel; any configuration that you apply to the physical interfaces affects only the
interface where you apply the configuration.
You cannot configure a 802.1X port in an EtherChannel.
Configuring Layer 3 EtherChannels, page 17-6
Configuring Layer 2 EtherChannels, page 17-9
Configuring the LACP System Priority and System ID, page 17-11
Configuring EtherChannel Load Balancing, page 17-12
Removing an Interface from an EtherChannel, page 17-13
Removing an EtherChannel, page 17-14
Creating Port-Channel Logical Interfaces, page 17-6
Configuring Physical Interfaces as Layer 3 EtherChannels, page 17-7
Chapter 17
17-5.)
Understanding and Configuring EtherChannel
"EtherChannel Configuration Guidelines
OL-6696-01
Advertisement
Table of Contents
