Table of Contents
Advertisement
The device driver is on the Resource CD-ROM that is shipped with the server.
The latest version of the driver is also available from:
http://www.pc.ibm.com/support
Installation procedures are documented in the following sections:
Windows: "Installing additional drivers" on page 144
Linux: "Upgrading drivers" on page 173
5.2.4 Configuring the remote control password
If you want to use the remote control features of the Remote Supervisor Adapter
Web interface, you must configure the remote control password using the
Configuration/Setup utility program.
To set up a remote control password, complete the following steps:
1. Start the server.
2. From the EFI Firmware Boot Manager startup options, select
Configuration/Setup and press Enter.
3. Select System Security.
4. Select Remote Control Security.
5. In the Enter New Remote Control Password field, enter the Remote Control
password that you wish to use each time you log into the remote control
features of the Remote Supervisor Adapter Web Interface. See Figure 5-5 on
page 187.
IBM Eserver xSeries 455 Planning and Installation Guide
186
Advertisement
Table of Contents
