Table of Contents
Advertisement
Note: The illustration shows a controller card with no network interface
cards installed. You do not need to remove network interface cards
before removing the controller card.
5. Lay the controller card on a flat surface.
6. To install a SIMM, see "Installing a SIMM". To install a hard drive, see
"Installing a Hard Drive" on page 168.
Installing a SIMM
Important!
Follow the instructions for handling static-sensitive devices described on
page 165.
Use the following procedure to install a SIMM:
1. Switch off the printer.
2. Unplug the printer.
3. Remove the controller card. See "Removing the Controller Card" on
page 166.
4. Locate the correct socket group for the type of SIMM you are installing.
There are two socket groups: one contains two sockets, the other contains
four sockets. You must install DRAM SIMMs (memory) in one of the
sockets in the socket group of two. You must install data stream SIMMs
and flash memory SIMMs in one of the sockets in the socket group of four.
Note: The position of the SIMM within a group of sockets does not matter
except for ease of insertion when you load more than one SIMM in
a socket group. Load the first SIMM in the DRAM SIMM socket
group in the socket closest to the edge of the controller card. Load
the first SIMM in the data stream or flash memory SIMM socket
Chapter 8. Installing Printer Options
167
Advertisement
Table of Contents
