Repeat Dialing; Call Forwarding - Siemens OpenStage 40 Administration Manual
Openscape voice
Hide thumbs
Also See for OpenStage 40:
- User manual (205 pages) ,
- Operating manual (144 pages) ,
- Administration manual (284 pages)
Table of Contents
Advertisement
3.7.3
Repeat Dialing
On key press, the call number that has been dialed lastly is dialed again.
The label displayed to the left of the key is defined in Key label <key number>.
Administration via WBM
System > Features > Program keys > Repeat dialling
3.7.4
Call Forwarding
This key function controls phone based call forwarding. If forwarding is enabled, the phone will
forward incoming calls to the predefined call number, depending on the current situation.
To use phone based call forwarding, Server features must be switched off (see
>
Section 3.6.11, "Server Based Features").
The label displayed to the left of the key is defined in Key label <key number>.
The Forwarding type parameter determines the forwarding behaviour. If "All calls" is selected,
any incoming call will be forwarded. If "On no reply" is set, the call will be forwarded when the
user has not answered within a specified timespan. The timespan is configured in the WBM
user pages under Configuration > Incoming calls > Forwarding > No replay delay (seconds). If
"On busy" is selected, incoming calls will be forwarded when the phone is busy.
Administration via WBM
System > Features > Program keys > Forwarding
A31003-O1010-M100-17-76A9, 09/09/2010
OpenScape Voice - OpenStage Family, Administration Manual
administration.fm
Administration
Free Programmable Keys
3-81
- Quick Links:
- Openstage 40
- Factory Reset
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
