Table of Contents
Advertisement
ASSEMBLY
Assembling the loop handlebar
(322C, 323C, 325Cx)
• Position
the handle on
the shaft. Note that the
handle must be mounted
below the arrow on the
shaft.
• Fit the bolt, securing plate
and wing nut as shown in
the diagram.
• Tighten
the wing nut.
Assembling the loop handlebar
(322L, 323L, 323LD, 325Lx, 325LxT, 325LDx)
Clip the loop handle onto
the shaft. Note that the
loop handle must be
fitted between the arrows
on the shaft.
• Slide the spacer into the
slot in the loop handle.
• 322L/323L/323LD:
Fit
the nut, washer and bolt.
325Lx/325LxJ325LDx:
Fit the nut, knob and
bolt. Do not overtighten.
•
Now
adjust the trimmer
to give a comfortable
working position. Tighten
the bolt/knob.
4
Assembling and dismantling the
two-part
shaft
(323LD, 325LxT, 325LDx)
Assembling:
• Make sure the handle is
loose.
Guide the cut-out on the
lower section of the shaft
into the coupling's
locking plate on the
upper section of the
shaft. The sections are
then locked together.
• Tighten
the handle.
Dismantling
• Undo the handle (at least
three turns).
• Press the handle towards
the coupling.
• Carefully twist the lower
section out of the lock.
Hold both parts of the
shaft and pull out the
lower section from the
coupling.
Assembly of the trimmer head
It is extremely important
that the disc drive's/support
flange's guide engages
correctly in the cutting
equipment's
centre hole
when assembling the cutting
equipment.
Cutting
equipment
assembled
incorrectly can result in
serious and/or
fatal personal
injury.
12
- English
- Quick Links:
- Fuel Mixture
- Carburettor
Hide quick links:
Advertisement
Table of Contents
