Table of Contents
Advertisement
Available languages
Available languages
ASSEMBLY
Correct
height
Adjust the harness
so that the cutting at-
tachment
is parallel to the ground.
Correct
balance
Let the cutting attachment
rest lightly on
the ground.
If you use a grass blade, it
shouM balance
about 10 cm above the
ground to prevent contact with stones
and
the like. Adjust the position
of the harness
clamp to balance
the unit correctly.
Fitting blades and trimmer
heads
• When fitting the cutting attachment
it is
extremely important that the raised section
on the drive disc/support
flange engages
correctly in the centre hole of the cutting
attachment.
If the cutting attachment
is
fitted incorrectly it can result in serious and/
or fatal personal injury,
_IbWARNING:
Never
use a cutting
attachment
without
an approved
guard.
See the section
on Techni-
cal data. If an incorrect
or faulty
guard
is fitted this can cause seri-
ous personal
injury.
IMPORTANT]
if a grass blade is to be used, the machine
must be equipped
with the correct
handle-
bar, blade guard and harness.
Fitting a blade guard, grass
blade and grass cutter
Hook the btade guard/combination
guard
(A) onto the fitting on the shaft and secure
with the bolt,
OAUTION?
Use the recommended
blade
guard, See the Technical
data section.
Fit the drive disc (B) on the output shaft.
Turn the blade shaft until one of the
hotes in the drive disc aligns with the
corresponding
hole in the gear housing,
Insert the locking
pin (C) in the hole to
tock the shaft,
Place the blade (D), support cup (E) and
support flange (F) on the output shaft.
Fit the nut (G). The nut must be tight-
ened to a torque of 35-50
Nm (3,5-5
kpm), Use the socket spanner
in the tool
kit, Hoid the shaft of the spanner
as
close to the blade guard as possible.
To
tighten the nut, turn the spanner
in the
opposite
direction
to the direction
of rota-
tion (CAUTION?
left-hand
thread),
Hide quick links:
Advertisement
Chapters
Table of Contents
