Table of Contents
Advertisement
Your dishwasher cleans by spraying a mixture of hot water and detergent through the spray arms against soiled surfaces.
Each cycle begins with a pre-drain. Next, the dishwasher fills with water covering the filter area. Water is then pumped
through the spray arms onto the dishware. Soil particles go down the drain as the water is pumped out and replaced with
clean water. The number of water fills will vary with the cycle being used. Features may vary by Model.
Nozzle and Upper SprayArm
TopRack
Tub Gasket
CupShelves
Bowlines
MiddleSprayArm
Lower Spray Arm
Detergent Dispenser
RinseAid
Dispenser
Vent
Serial Label
(located on right
side of tub)
Silverware
Basket
Bottom Rack
GlassTrap
Heating Element
* Appearance
may vary from your model.
Getting
Started
1.
Load dishwasher
2.
Add detergent
3.
Add rinse aid
4.
Select desired CYCLE.The indicator light above the
pad will glow when selected.
5.
Select desired OPTIONS. The indicator light above the
pad will glow when selected.
6.
Run hot water faucet nearest dishwasher until water is
hot. Turn water off.
7.
To start, press START/CANCEL pad.
8. Close door to latch.
customize your dishwasher to match your cabinets:
You will need a Trim Kit.
See Step 10 of the Installation Instructions that came
with your dishwasher for more information.
Hide quick links:
Advertisement
Table of Contents
