Table of Contents
Related Manuals for Miele DA 5490 W
Summary of Contents for Miele DA 5490 W
- Page 1 Operating and installation instructions Cooker hood DA 5490 W en - GB, AU, NZ To avoid the risk of accidents or damage to this appliance it is essential to read these instructions before it is installed and used for the first time.
-
Page 2: Table Of Contents
Contents Caring for the environment ......... . 3 Warning and Safety instructions . -
Page 3: Caring For The Environment
Caring for the environment Disposal of the packing Disposal of your old appliance material Electrical and electronic appliances often contain materials which, if The transport and protective packing handled or disposed of incorrectly, has been selected from materials which could be potentially hazardous to are environmentally friendly for human health and to the environment. -
Page 4: Warning And Safety Instructions
Warning and Safety instructions This appliance is not intended for This appliance complies with all use by persons (including children) relevant local and national safety with reduced physical, sensory or requirements. Inappropriate use mental capabilities, or lack of can, however, lead to personal injury experience or knowledge, unless they and damage to property. - Page 5 Miele authorised person in accordance the data plate correspond with the with current national and local safety on-site electricity supply, otherwise the regulations.
- Page 6 Warning and Safety instructions Do not connect the appliance to the Using at the same time as other mains electricity supply by a heating appliances that depend on multi-socket unit or an extension lead. the air from the room These do not guarantee the required safety of the appliance (e.g.
- Page 7 The Miele DSM 400 control module only be switched on when the heating offers the possibility of combining other appliance is switched off or vice versa.
-
Page 8: Correct Use
Warning and Safety instructions Correct use Do not use the cooker hood without the filters in place. This way you will Never use an open flame beneath avoid the risk of grease and dirt getting the cooker hood. To avoid the danger into the appliance and hindering its of fire, do not flambé... - Page 9 Safety regulations prohibit the fitting of a cooker hood over solid fuel stoves. All ducting, pipework and fittings must be of non-flammable material. These can be obtained from the Miele Spare Parts department or from builders' merchants. The appliance must not be connected to a chimney or vent flue which is in use.
-
Page 10: Guide To The Appliance
Guide to the appliance... - Page 11 Guide to the appliance Extension piece Tower Canopy Touch controls Grease filters Recirculation grille (only for recirculation mode) Hob lighting Charcoal filter (special accessory for recirculation mode) On/Off touch control for the fan Controls to select fan power level On/Off touch control for hob lighting...
-
Page 12: Modes Of Operation
Modes of operation The cooker hood works with . . . air extraction: . . . air recirculation: (available as an optional extra with a conversion kit and charcoal filter: see "Technical Data") The air is drawn in and cleaned by the grease filters and directed outside. -
Page 13: Operation
If the cooker hood has been To switch the lighting on and off connected to a window contact switch via the Miele DSM 400 control The hob lighting can be switched on module, then the fan cannot be and off independently of the fan. - Page 14 Operation ^ Press the + control to activate the Automatic switch-off of the Intensive setting automatic switch-off. The indicator lamps for fan power You can set the Intensive setting so that levels I and IV will now light up it only runs for 10 minutes before constantly.
-
Page 15: Cleaning And Care
– abrasive cleaning agents, e.g. cleaning the appliance. powder cleaners or cream cleaners and abrasive sponges, as well as pot A range of Miele branded cleaning and scourers or sponges which have conditioning agents are available to been used previously with abrasive order through your Miele Dealer / cleaning agents. -
Page 16: Grease Filters
Cleaning and care Grease filters Important for appliances with lacquered housing The re-usable metal grease filters in the appliance remove solid particles (special order finish) (grease, dust, etc.) from the kitchen It is very difficult to clean this type of vapours, preventing soiling of the surface without causing minor marks to cooker hood. - Page 17 65°C programme, ensuring the spray screwdriver blade into the slit to arm is not obstructed. If a Miele disengage the clip. dishwasher is being used, select the Sensor wash programme.
-
Page 18: Fitting And Replacing The Charcoal Filter
It is fitted in the canopy above the household waste. grease filters. New filters can be purchased from your Miele Dealer / Chartered Agent from the Miele Spare Parts Department or via the internet on www.miele.co.uk. See back cover for contact details, and "Technical data"... -
Page 19: Changing A Halogen Lamp
Cleaning and care Changing a halogen lamp ^ Before any maintenance work is carried out, disconnect the cooker hood from the mains supply. Ensure that: – it is switched off at the isolator, or – it is switched off at the wall socket and the plug removed, or –... -
Page 20: After Sales Service
650 mm above an open grill or deep fat fryer, 650 mm above gas hobs and cookers. If this cooker hood is installed above a Miele Wok CS 1028 CombiSet 1) Extraction appliance, a minimum safety distance of 760 mm must be 2) Recirculation... -
Page 21: Appliance Dimensions
Appliance dimensions – When deciding on the safety distance between the hob and cooker hood, please note that a distance of 650 mm above electric cookers/hobs may be preferable to give more working space under the hood. – Account should also be taken of the height of the person who will be using the hood most often. -
Page 22: Installation
Installation Assembly parts... - Page 23 Installation 3 protective sheets for use when fitting the tower. 2 hose clips for securing the 2 x M 6 self-tapping nuts for securing exhaust ducting. the appliance. 1 reducing collar for C 125 mm exhaust ducting. 1 non-return valve 2 screws 3.9 x 7.5 mm for fitting into the exhaust connection for securing the tower.
-
Page 24: Installation Instructions
Installation Dismantling Before installation, it is important Should the appliance ever need to be to read the information given on the dismantled, follow the installation following pages as well as the instructions in reverse order as "Appliance dimensions" and the described on the installation sheet. -
Page 25: Connection For Air Extraction
Connection for air extraction Important: To avoid the danger If the exhaust ducting is secured to of toxic fumes, please observe the the exhaust stub by a hose clip, Warning and Safety instructions. ensure that it is fitted correctly. Do This is especially crucial when using not overtighten. -
Page 26: Condensate Trap
Connection for air extraction Important: If the exhaust ducting is to run through rooms, ceiling space etc. where there may be great variations in temperature between the different areas, the problem of condensation will need to be addressed. The exhaust ducting will need to be suitably insulated. -
Page 27: Electrical Connection
Electrical connection If the switch is not accessible after All electrical work should be installation (depending on country), an undertaken by a suitably qualified additional means of disconnection must and competent person in strict be provided for all poles. accordance with current national For extra safety it is advisable to protect and local safety regulations the appliance with a suitable residual... -
Page 28: Operation With Control Module Dsm 400
Operation with Control module DSM 400 The Miele DSM 400 Control module can If the control module is disconnected be used to combine the cooker hood in order to operate the cooker hood with other components. without the window contact switch It enables the following: (e.g. -
Page 29: Connection To A Light Switch
Operation with Control module DSM 400 Connection to a light switch The control module can be used to switch on the cooker hood lighting via a light switch in the house. Installation The tower needs to be removed before the control module can be fitted to the fan unit. - Page 30 In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer / Chartered Agent – The Miele Customer Contact Centre (see back cover for address). When contacting your Dealer or Miele, please quote the model and serial number of your appliance.
-
Page 31: Technical Data
- Fan motor ....295 W – Miele charcoal filter DKF 12-1 - Hob lighting ....2 x 20 W Voltage . - Page 36 Alteration rights reserved / 4209 M.-Nr. 07 031 980 / 08...