Configure The Management Port Ip Address; Configure A Management Route - Dell Force10 C150 Configuration Manual
Ftos configuration guide ftos 8.4.2.7 e-series terascale, c-series, s-series (s50/s25)
Hide thumbs
Also See for Force10 C150:
- Manual (57 pages) ,
- Manual (66 pages) ,
- Quick start manual (33 pages)
Table of Contents
Advertisement
Configure the Management Port IP Address
Assign IP addresses to the management ports in order to access the system remotely.
Note: Assign different IP addresses to each RPM's management port.
To configure the management port IP address:
Step
Task
1
Enter INTERFACE mode for the
Management port.
2
Assign an IPv4 or IPv6 address to
the interface.
3
Enable the interface.
Configure a Management Route
Define a path from the system to the network from which you are accessing the system remotely.
Management routes are separate from IP routes and are only used to manage the system through the
management port.
To configure a management route:
Step
Task
Configure an IPv4 or IPv6
1
management route to the network
from which you are accessing the
system.
Configure a Username and Password
Configure a system username and password to access the system remotely.
48
|
Getting Started
Command Syntax
interface ManagementEthernet
•
slot
range: 0 to 1
•
range: 0
port
ip address {
ipv4-address
•
ipv4-address:
an address in dotted-decimal
format (A.B.C.D).
•
ipv6-address:
an address in hexadecimal format
(X:X:X:X::X).
•
mask:
a subnet mask in /prefix-length format (/
xx).
no shutdown
Command Syntax
management route
{
ipv4-address
mask gateway
•
the network address in
ip-address:
dotted-decimal format (A.B.C.D).
•
a subnet mask in /prefix-length format (/
mask:
xx).
•
: the next hop for network traffic
gateway
originating from the management port.
slot/port
|
ipv6-address
}
/mask
|
}/
ipv6-address
Command Mode
CONFIGURATION
INTERFACE
INTERFACE
Command Mode
CONFIGURATION
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
