Related Manuals for Electrolux EW1220N
Summary of Contents for Electrolux EW1220N
- Page 1 WASHING MACHINE ÇAMAÇIR MAKINESI INSTRUCTION BOOKLET KULLANIM KILAVUZU EW 1220N EW 1620N 132 993 580...
- Page 2 Dear customer, Please read these operating instructions carefully and pay particular attention to the safety notes indicated in the first pages. We recommend that you keep this instruction booklet for future reference and pass it on to any future owners. Transport damages When unpacking the appliance, check that it is not damaged.
-
Page 3: Table Of Contents
Contents Warnings Control panel Disposal Controls 10-13 Washing hints Tips for environmental protection 5 Sorting the laundry Temperatures Technical specifications Before loading the laundry Maximum loads Installation Laundry weights Unpacking Removing stains Positioning Detergents and additives Water inlet “Jet System” wash Water drainage Operating sequence 16-18... -
Page 4: Warnings
Warnings The following warnings are provided in the interests of overall safety. You must read them carefully before installing or using the appliance. General safety • Do not use your machine for dry cleaning. • Dyes and bleaching agents may only be used if •... -
Page 5: Disposal
Disposal Packaging materials Machine The materials marked with the symbol Use authorised disposal sites for your old appliance. recyclable. Help to keep your country tidy! >PE<=polyethylene >PS<=polystyrene >PP<=polypropylene This means that they can be recycled by disposing of them properly in appropriate collection containers. Tips for environmental protection To save water, energy and to help protect the •... -
Page 6: Technical Specifications
Technical specifications DIMENSIONS Height 85 cm Width 60 cm Depth 62 cm MAXIMUM LOAD Cotton Synthetics 2,5 kg Delicates 2,5 kg Woollens / Hand wash SPIN SPEED 1200 rpm max. (EW 1200N) 1600 rpm max. (EW 1600N) POWER SUPPLY VOLTAGE/FREQUENCY 220-230 V/50 Hz TOTAL POWER ABSORBED 2200 W... -
Page 7: Installation
Installation Unpacking 7. Plug the open holes with the plugs which are supplied with the instruction booklet. All transit bolts and packing must be removed before using the appliance. You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again. -
Page 8: Water Drainage
Water drainage Electrical connection The end of the drain hose can be positioned in three This machine is designed to operate on a 220-230 V, ways: single-phase, 50 Hz supply. Hooked over the edge of a sink using the plastic Check that your domestic electrical installation can hose guide supplied with the machine. -
Page 9: Your New Washing Machine
Your new washing machine This new machine, which is fitted with the Direct Spray system, patented Electrolux, meets all modern needs for effective treatment of laundry with low water, energy and detergent consumption. Further savings are achieved by washing small loads of laundry, since water and electricity consumption is proportional to the quantity and type of laundry being washed. -
Page 10: Use
Control panel proposed by the washing machine. The relevant light 1 ON/OFF button (Açma/Kapama) will light up. Press this button to switch the washing machine on. Maximum temperatures are 95°C for cotton, 60°C for The display (8) will show three blinking dashes or a synthetic fabrics, 40°C for delicate fabrics, wool and blinking zero. - Page 11 • Draining and spin: switch the machine on, if the previously selected - Press the START/PAUSE button. The machine will cycle has been erased. drain the water, then spin the laundry at the maximum speed provided for the performed programme. - Select spin speed by means of button 5, and press the START/PAUSE button.
-
Page 12: Skip/Reset Button
tests, and this cycle has not been erased after its 9 START/PAUSE button completion. (Baçlat/Beklet) • Delay start, a time value indicated in hours and This button has three functions: selected by means of the relevant button (GECIKTIRME). • Start: after you have selected the desired programme and options, press this button to start the The delay time is displayed for 5 seconds, then the washing machine. -
Page 13: Delay Start Button
Example: 11 DELAY START button In this case, both the (GECIKTIRME) drain and the spin (at PREWASH ÖN YIKAMA This button makes it possible to delay the starting of the speed provided for WASH the programme by up to 24 hours. The delay you the selected type of YIKAMA have selected is shown on the display for about 5... -
Page 14: Washing Hints
Laundry weights Washing hints The following weights are indicative: bathrobe 1200 g Sorting the laundry napkin 100 g Follow the wash code symbols on each garment quilt cover 700 g label and the manufacturer’s washing instructions. Sort the laundry as follows: sheet 500 g whites, coloureds, synthetics, delicates, woollens. -
Page 15: Detergents And Additives
Ink: depending on the type of ink, moisten the fabric Quantity of detergent to be used first with acetone (*), then with acetic acid; treat any The type and quantity of detergent will depend on residual marks on white fabrics with bleach and then the type of fabric, load size, degree of soiling and rinse thoroughly. -
Page 16: Operating Sequence
4. Switch the machine on Operating sequence Press the ON/OFF button (AÇMA KAPAMA) to Before washing your first load of laundry, we switch the machine on. The display will show three recommend that you run a cotton cycle at 60°C, with blinking dashes or a blinking zero. -
Page 17: Select The Temperature
6 Select the temperature 9 Select the QUICK WASH option (HIZLI YIKAMA) Press the TEMPERATURE button SICAKLIK if you wish to select a temperature value different from the Depress button HIZLI YIKAMA to select the QUICK one proposed by the washing machine or the COLD WASH option, if your laundry is only slightly soiled. -
Page 18: How To Change A Programme During Its Cycle
12 How to change a programme should it be absolutely necessary to do so, switch the machine off by pressing the ON/OFF button during its cycle “AÇMA/KAPAMA”. After approximately 2 minutes, you can open the Before you make any change, you must pause the door. -
Page 19: Washing Programmes
Programme chart Washing programmes Consumption** Additional Max. Wash programme Temp. Fabrics functions load Energy Water Time min. SPIN SPEED Cotton fabrics RINSE HOLD Cottons (Whites) e.g. sheets, 60°-95° PREWASH 5 kg Beyazlar tablecloths, SUPER RINSE household, linen QUICK Coloured cotton or SPIN SPEED Cottons * 60°-40°-30°... -
Page 20: International Wash Code Symbols
International wash code symbols These symbols appear on fabric labels, in order to help you choose the best way to treat your laundry. Energetic wash Max. wash Max. wash Max. wash Max. wash temperature temperature temperature temperature 95°C 60°C 40°C 30°C Hand wash Do not... -
Page 21: Cleaning And Maintenance
Cleaning and maintenance 1. After each wash 4. Door seal At the end of the wash programme, pull the Check from time to time the door seal and eliminate dispenser drawer out a little to let it dry. eventual possible objects that could be trapped in Leave the door ajar to allow air to circulate. -
Page 22: Water Inlet Filter
6. Water inlet filter 8. The dangers of freezing If you notice that the machine is taking longer to fill, If the machine is exposed to temperatures below check that the filter in the water inlet hose is not 0°C, certain precautions should be taken. blocked. -
Page 23: Something Not Working
Something not working? Problems which you can resolve yourself. During machine operation it is possible that one of the following alarm codes appears on the display: - E10 : problem with the water supply - E20 : problem with water draining - E40 : door open Once the problem has been eliminated, press the START/PAUSE button to restart the programme. -
Page 24: Laundry Is Not Spun Enough
Problem Possible cause • Spinning starts late or the • The electronic unbalance detection device has cut in because the laundry is not evenly distributed in laundry is not spun enough: the drum. The laundry is redistributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume.