WARNINGS the scraper provided. Under no circumstances It is most important that this instruction book should should solid ice be forced off the liner. Solid ice be retained with the appliance for future reference. Should the appliance be sold or transferred to another should be allowed to thaw when defrosting the appliance.
INSTALLATION If this appliance featuring magnetic door seals is to Rear spacers replace an older appliance having a spring lock (latch) The plastic bag containing all relevant on the door or lid, be sure to make that spring lock documentation also contains two spacers to be fitted unusable before you discard the old appliance.
Page 5
Door reversibility Fig. 3 Before carrying out any work, remove the plug from the power socket. To change the opening direction of the doors proceed as follows: Remove the lower hinge (3), the pin (1) and the support foot (2). Remove the centre hinge and slide the top door off pin (5);...
Butter and cheese: these should be placed in special Operation airtight containers or wrapped in aluminium foil or Insert the plug into the wall socket. polythene bags to exclude as much air as possible. Open the refrigerator door and turn the thermostat Milk bottles: these should have a cap and should be knob, clockwise, beyond the «O»...
the freezing process takes 24 hours. No further food Positioning the door shelves to be frozen should be added during this period; To permit storage of food packages of various sizes, only freeze top quality, fresh and thoroughly the door shelves can be adjusted in height. cleaned, foodstuffs;...
The freezer compartment, however, will become Important progressively covered with frost. This should be If there is a power failure when food is in the freezer, removed with the special plastic scraper provided, do not open the door of the freezer compartment. The whenever the thickness of the frost exceeds 4 mm.
MAINTENANCE Unplug the appliance before carrying out any Interior light maintenance operation. The light bulb inside the refrigerator compartment can be reached as follows: Warning unscrew the light cover securing screws; This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore unhook the moving part by pressing it as shown only be carried out by authorized technicians.
Page 10
AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg Copyright by AEG H 271 271 300 - 0797/03 - 151 2222 019-12 1 2 3 4 5 6 7 8 9 10 11 12 / 97...