Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Hitachi RAS-10CZJ
Summary of Contents for Hitachi RAS-10CZJ
- Page 1 SPLIT TYPE AIR CONDITIONER INDOOR UNIT/OUTDOOR UNIT MODEL RAS-10CZJ/RAC-10CZJ RAS-13CZJ/RAC-13CZJ OUTDOOR UNIT INDOOR UNIT RAC-10CZJ RAS-10CZJ RAS-13CZJ RAC-13CZJ Instruction manual To obtain the best performance please read this instruction manual completely. Page 1~20...
-
Page 2: Safety Precaution
SAFETY PRECAUTION Please read the “ Safety Precaution ” carefully before operating the unit to ensure correct usage of the unit. • Pay special attention to signs of “ Warning ” and “ Caution ” . The “ Warning ” section contains matters which,if •... - Page 3 PRECAUTIONS DURING OPERATION • Do not connect the power cable with an extension cable or do not plug too many leads of the other electric appliance into the socket where this cable is plugged. In addition, wire the cable with some allowances to prevent the cable from stretching. Not doing so will cause an electrical shock, heat generation or fire.
-
Page 4: Names And Functions Of Each Part
NAMES AND FUNCTIONS OF EACH PART INDOOR UNIT PRE-FILTER To prevent dust from coming into the door unit. (Refer page 16) INDOOR UNIT INDICATORS Light indicator showing the operating condition. (Refer page 5) FRONT PANEL HORIZONTAL DEFLECTOR • VERTICAL DEFLECTOR (AIR OUTLET) (Refer page 12) REMOTE CONTROL Send out operation signal to the indoor unit so as to... -
Page 5: Operation Indicator
RECEIVABLE INDICATOR FUNCTIONS Operation Lamp (YELLOW) This lamp lights during operation. Timer Lamp (ORANGE) This lamp lights when the timer is working. The lamp flashes periodically when any abnormality occurs in the indoor unit. Temporary Switch OPERATION INDICATOR TEMPORARY SWITCH When the remote control device is not functioning, use the Temporary Switch mode c t i l l i... -
Page 6: Names And Functions Of Remote Control Unit
NAMES AND FUNCTIONS OF REMOTE CONTROL UNIT REMOTE CONTROLLER This controls the operation of the indoor unit. Signal range to reach indoor unit is about 7 meters. This unit can be fi xed on a wall using the fixture provided. Before fixing it, make sure the indoor unit can be controlled from the remote controller. -
Page 7: Cooling Operation
COOLING OPERATION Use the device for cooling when the outdoor temperature is 21-43 ° C. If humidity is very high (over 80 ° C) indoors, some dew may form on the air outlet grille of the indoor unit. Press the button so that the display indicates COOLING Cooling operation starts with a beep. -
Page 8: Dehumidifying Operation
DEHUMIDIFYING OPERATION Use the device for dehumidifying when the room temperature is over 16 ° C. When it is under 15 ° C, the dehumidifying function will not work. Press the Press the (DEHUMIDIFY) button. (DEHUMIDIFY) button. Dehumidifying operation starts with a beep. The FAN SPEED is set at LOW automatically. -
Page 9: Circulation Operation
CIRCULATION OPERATION Press the button so that the display indicates (CIRCULATE). Circulating operation starts with a beep. Press the FAN SPEED button and select the desired FAN SPEED (the display indicates your choice). Press the temperature control button to set to the desired temperature. -
Page 10: How To Set The Sleep Timer
HOW TO SET THE SLEEP TIMER Press the (SLEEP) button, and the display changes as shown below. Mode Indication 1 hour 2 hours 3 hours 7 hours Sleep timer Sleep timer off Sleep Timer: The device will continue working for the designated number of hours and then turn off. -
Page 11: How To Set The Timer
HOW TO SET THE TIMER ■ ON Timer and OFF Timer are available. ■ Operation stop at setting time OFF Timer Reservation OFF TIME setting • Select the OFF TIME by pressing the (OFF) Button. • Setting time will change according to the below sequence when you press the button. -
Page 12: Air Flow Louvers Adjustments
AIR FLOW LOUVERS ADJUSTMENTS Adjustment of the conditioned air in the upward and downward directions. The horizontal air deflector is automatically set to the proper angle suitable for each operation. The deflector can be swung up and down continuously and also set to the desired angle using the “... -
Page 13: How To Exchange The Batteries In The Remote Controller
HOW TO EXCHANGE THE BATTERIES IN THE REMOTE CONTROLLER When using the remote controller, if there is no response from the air conditioner unit and or the remote control has fading and dim displays, the batteries in the remote control device need to be removed and replaced with new ones Remove the cover as shown in the fi... - Page 14 THE IDEAL WAYS OF OPERATION Suitable Room Temperature Install curtain or blinds I t i s p o s s i b l e Warning to reduce heat Freezing temperature entering the room is bad for health and a through windows. waste of electric power.
- Page 15 FOR USER ’ S INFORMATION The Air Conditioner And The Heat Source In The Room Caution If the amount of heat in the room is above the cooling capability of the air conditioner (for example: more people entering the room, using heating equipments and etc.), the preset room temperature cannot be achieved.
- Page 16 MAINTENANCE OF THE UNITS CAUTION Ensure that the unit is not in operation and all power supply has been disconnected before cleaning the units. Pre-filter Pre-filter are installed to remove the indoor dust particles hence they should be kept clean at all times. They should be cleaned at each machine operation cycle of approximately 100 hours.
-
Page 17: Cleaning The Front Panel
Front panel can easily get dirty. Use a soft cloth to wipe it. If the front panel is excessively dirty, wipe the front panel with a soft cloth either wet with warm water or containing a mild detergent after which, wipe dry the front panel with a soft dry cloth. Do not use hot water (50 °... - Page 18 AFTER SALE SETVICE AND WARRANTY WHEN ASKING FOR SERVICE, CHECK THE FOLLOWING POINTS. CONDITION CHECK THE FOLLOWING POINTS • Is the fuse all right? • When it does not operate Is the voltage extremely high or low? • Is the circuit breaker “ ON ” ? •...
- Page 19 This product conforms with the protection requirements of council directives 89/336/EEC relating to electromagnetic compatibility and 73/23/EEC relating to electrical equipment designed for use within certain voltage limits. Please note: On switching on the equipment, particularly when the room light is dimmed, a slight brightness fluctuation may occur.
- Page 20 MEMO - 21 -...
- Page 21 Made in China Hitachi Household Appliances ( Wuhu ) Co.,Ltd.