Preparation Of Top Cabinet; Assemble And Install Adaptor; Mount The Oven - GE PSA1200 Installation Instructions Manual
Above the cooktop oven
Hide thumbs
Also See for PSA1200:
- Owner's manual (80 pages) ,
- Installation instructions manual (48 pages) ,
- Owner's manual (80 pages)
Table of Contents
Advertisement
Available languages
Available languages
Installation
Instructions
|
USE TOP CABINET TEMPLATE FOR
PREPARATION OF TOP CABINET
You need to drill holes for the top support screws,
a hole large enough for the power cord to fit through,
and a cutout large enough for the exhaust adaptor.
• Read the instructions on the TOP CABINETTEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the TOP
CABINETTEMPLATE.
A ,,-^, ,T,,-,_,
Al_,,/_Id/I
UI_I
: Wear safety goggles when
drilling holes in the cabinet bottom.
ASSEMBLE AND INSTALL ADAPTOR
_
Damper
,_i
Exhaust
Adaptor
II_
_
Blower P late
Oven
Place the oven in its upright position, with the top
of the unit facing up.
[_] Insert the tabs on each side of the damper into
the holes at the inside rear of the adaptor.
[_ Attach the exhaust adaptor to the blower plate with
the two bronze metal screws provided.
Make sure that the damper pivots easily before
mounting oven.
You will need to make adjustments to assure proper
alignment with your house exhaust duct after the
oven is installed.
F-_I
MOUNT THE OVEN
_ACAUTI e
risk
of personal
injury iback injury or other injuries due to excessive
weight of the microwave oven} or property damage,
you will need two people to install this microwave
oven.
IMPORTANT: Do not grip or use handle during
installation.
AI;Ik V_//_I_I_I
I I_1_._: Risk of Electric Shock. Can
cause injury or death: If installing unit with metal
countertops,
cover the edge of the power supply
cord hole with the power supply cord bushing.
IMPORTANT: If filler blocks are not used, case damage
may occur from overtightening screws.
NOTE:When mounting
the microwave oven,
thread power cord through
hole in bottom of top
cabinet. Keep it tight
throughout Steps 3_-3.Do
not pinch cord or lift oven
by pulling
E_] Lift microwave oven,
tilt it forward, and hook
slots at back bottom
edge onto four lower
tabs of mounting plate.
Rotate front of oven up
against cabinet bottom.
[_ Insert a self-aligning screw through top-center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after
the threads have engaged. (It will be completely
tightened later.)
13
Advertisement
Chapters
Table of Contents
